P code 0562. A code 51

Hi all,

Thanks in advance for any help here.

08 Gen 2 21,000 miles covered.

Bike runs fine. Only had the odd fault code come up from time to time. Reset no further issues. Till today.
On the way home 90 mile ride out and the bike starts popping and banging on the over run. No usually a bad thing and sounds great. Starts to run lumpy and won't rev past about 3000 rpm. The clocks are flickering on and off and it did this for about the last 5 miles and then 1/4 from home it died. No restart the clocks wind up and the pump primes but all you get is clicking, as thought the battery is dead. Pushed it home?

Battery completely flat. The battery is I know first class. Varta Funstart 230 crank amps and was fully charged at start of ride out.

My theory is

A. The generator has given up and from the point it started to pop and bang the bike ran on battery power till it was flat.

B. The Reg/Rec is banjaxed as well and both need replacing

Last week had fault code P-0600. Reset ok.

Today fault codes are P code 0562 Battery voltage high and A code 51 Battery voltage low. Very confusing.

I awaite any Devine guidance from a Tuono Guru.

Thanks

Daz

Stator, brown plug
check condition of brown connectors.
check the output on the yellow wires any pair about 60v ac at about 3-4000 rpm

Loads of information on here it quite a common issue and relativley easy fix if you mechanically minded.

Good luck with it

hs2300 said:

Stator, brown plug
check condition of brown connectors.
check the output on the yellow wires any pair about 60v ac at about 3-4000 rpm

Loads of information on here it quite a common issue and relativley easy fix if you mechanically minded.

Good luck with it

Click to expand...

Thanks,

With all the help I've had from the linked forums I think I can sort this. What I would like is any info on the best replacement stator. Don't want this again in 18,000 miles.

Recommendations anyone!

Thanks again.