problem

Hi All. Once again thanks for all your help. I have now bypassed the sidestand, the clutch is still slipping badly. I removed the slave cylinder, the clutch was fine. As soon as i tighten it up the clutch slips again. I removed some fluid as it seemed ok untill i pumped the lever. It seems as if...

I've searched the Internet a bit and nobody seems to have an answer for this one. When my starter relay began failing last week, the tach needle jumped all over the place so much that now it rests up at 12k. It seems to rev normally but is 5k to the left of where it should be. So when I rev...

Hello guys Today i removed my throttle bodies to have a look at the injectors and fuel tank for a closer inspection of the the pump and filter. When i had the throttle bodies off i removed the right side injector to see how clean the inside fuel channels were, all appeared clear with no debris...

Hey guys, Got my first T 06 a month ago, before buying she started with no problems (she was well look after). Previous owner put the new battery, but could't charge it properly (he put the battery same day I bought her). When due to circumstances had to leave her in the cold for a month...

Right guys need help and fast before i go mad!!! basically my 2002 Mille spins over but wont fire. Floods everytime after a few seconds of turning over, and before anyone says it NO i am not touching the throttle! pulled the plugs and they are sparking but soaking wet with fuel. could my problem...

Imagine you are racing down the road circa 140 all of a sudden the bike comes to a complete stop really fast, you are trying to get down the gearbox quick to stop losing it. Put the bike in neutral, engine is still running, you get off cannot find anything wrong you try to push the bike both...

My clutch lever intermittently goes all floppy from cold and I have got very little travel and obviously gear selection is difficult. Goes away when warm after a few pumps. So apart from viagra (anybody want some let me know) in the fluid, can I sort it myself or is it a dealer job?

I have taken my rsv 2004 for its second spin and it seems to have a problem when the temp gets over 90degrees. This is after an hour riding reasonably hard then getting through town the temp goes up, It then doesnt perform on full power. I have read previous invoices that i got with the bike and...

got my new front stand for my 02 rsvr and dont see a good way to get it up. Its one that connects to the bike between the forks up above the fender. Problem is, I dont see anything that will accept a 27mm diameter pin as suggested by the dealer. Only possibility is a hole that is maybe 10mm...

right i have seemed to of developed a problem, i now seem to have a slight missfire/hesitation, now and again at low revs (but not all the time). It was there when i brought the bike but traced it to the alarm which is now off of the bike, once that was off it has run fine for a year but now...

To avoid offence.....I would appreciate any info on the following. I am new to the site and will risk throwing this one in at this early stage. I would wait for a few months and few hundred visits but the problem is current and bugging me. I have a 2007 tuono which has an engine cut out...

hi dudes, got a rsv1000r. great bike. last couple of time i started it i got a small amount of coolant leaking from top radiator hose. it stops dripping after about a minute. this time the bike seam to get hot very quickly. anyone with any ideas.

I have a 2007 tuono which has an engine cut out issue. I'd start it up and run it for a few minutes then ride off. About 2 miles down the road... complete shut down as if someone has taken the keys out. I'd leave it for a few minutes and then it would start up again.... a mile later same...

Can anyone offer advice. I've got a 2000 mille and sometimes when I press the starter, it only just manages to turn the engine over. Next press and it either does same again or it turns it over properly and starts up. It's intermittent and the battery's always on optimate charger. Is this a bad...

I know we have had a lot of rain lately but I was not expecting this

Hi guys, anyone with the same problem? The right passenger footrest bracket that also holds the exhaust is fixed with two bolts. The bolts go in two plugs that are welded on the inside only in one of the tubes of the subframe. My mille has a broken weld of the rear-most of the two plugs. If you...

Hi all. I have just fitted a power commander to my 04 rsv factory r. I have also fitted the 02 sensor bypass. The problem i now am having is that ocasionally when the bike ticks over the eci light comes on. Any one else had this problem? Cheers Tim

hi again, I'm having a problem that now happened 3 times after some hard riding with brights on. slowed down and switched off bike, when trying to start again after couple of minutes, I seem to drain the battery as starter engages and then resets the the settings on the clock, rev counter...

I have had my tuono for only a couple of weeks now its a new shape tuono on a 56 plate with just under 10000 miles. Over the past couple of days i have found that the bike has lost power suddenly and has even stalled a couple of times ( usually after giving it some !!!). I have read a couple of...

Hi folks. I have said hello in the noob section so hi to everyone as i've just bought a mille.............. and its now broken! Can you help? Was fine when i bought it but now it wont go into 1st or neutral but sits in 2nd, although it will change up the box?? Also when i change up the...