twin can conversion

Aprilia Forum

Help Support Aprilia Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Glen, the mechanical stuff, I`m not great at, so I can`t help you there, but I can get around Photoshop a bit, so if you want to post up a decent pic, and let me know what you want, I might be able to assist you with the red/orange colour on the tail piece, to give you an idea of how it might look ?

Let me know if you want it done......

that would be great, i will sort a pic, and uplaod it cheers
:thumbup
 
Watch out for these 1 - 2 systems, where they cross over the swing arm they can get damn hot and have been known to cause heat damage to the huggers.

No problems with mine!!!!
 
Watch out for these 1 - 2 systems, where they cross over the swing arm they can get damn hot and have been known to cause heat damage to the huggers.

Far better off with a 2 - 2 system.



I'll second that,my bike had a set up like that one at one time,you can see where it melted the rear edge of the battery box.
 
I'll swap you my twin can set up for your single? (1 into 2 high level system)
 
Hi hooked,

Have pm'ed you so as not to hijack the thread.

Cheers

Paul
 
If you like the carbon fibre look can then it has to be one that has an internal liner, otherwise it will get blown apart by the exhaust pulses. (Most cans are lined these days)

The oval carbon Scorpions for the Mille aren't. I've just had mine sent back under warranty as the carbon sleeve was tearing where the rivets went thru the inlet cap.

I had hoped to get it changed to a titanium sleeve if I paid the extra but they just rebuilt it with a new sleeve and sent it back.

Just a case of hoping for the best now :dunno

Only saving grace is it sounds really good,looks nice and is as light as a feather.
 

New Posts

Back
Top