Misting Clocks

Aprilia Forum

Help Support Aprilia Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Dec 6, 2009
Messages
23
Location
Macclesfield
Where have all the misting clocks gone ? all fixed then!!! Ive had my bike for 3 months now never once misted up yeahhhhh, but have only been round the block twice !! LOL
 
i had brand new ones fitted under warranty .... :thumbup
no more mist for me :cheers
 
The clocks on mine were replaced under warranty before i got the bike. Out today and they misted up. Its only the second time i have been out on bike, warranty out now so guess it will be misty for me from now on.:dunno
 
Nah, it comes and goes mate. Depends a lot on how it's stored/washed/weather etc.

I fully expect mine to be clear if I check it 2moro. (puts foot firmly in mouth)
 
Luckily, mine just mists in the bottom right corner - not enough to worry about so says the dealer. Wondering whether there is condensation building somewhere it can't be seen like the ******* electronics. I'll keep an eye on it and may have to be a bit more insistent upon getting them replaced when I take it in for the next service.
 
i had mine replaced under warrenty but the new clocks misted up as well, the dealer told me the problem hasn't been fixed even on the new clocks so even if they replaced them again the misting could still occur
 
ive been out a few times since the clocks got changed ..
in bad weather and warmish weather ,cold weather, no misting at all as yet ...
fingers crossed , i may have a good one lol
 
misting

mine's kept inside and hasn't seen rain for months but yes the clocks mist up down low on the dial, has been a humid summer but
 
Took mine out the other day, and got about 1/2 inch bottom of the clocks. First time sonce I got the bike. Was a bit pissed off when I saw it. Has to be the weather, it is stored in a cold garage, and the sun was on it while out.
 
My clocks also showed some mist on the bottom right corner. I don't ride in the rain anymore, so I'll just let it be.
 
Mine have never misted up (smug Ba*****)

There is a fix on the AF1 sight where you open the clocks ,clean and rebuild using silicon . Worth a read even if you are not going to try.
Apparently it is down to when they are building up he clocks in the factory , temp?.
 
mine has misted up a couple of times in the bottom right corner as well. Will try to get a replacement next service and i will keep getting them replaced until warranty is up.
 

New Posts

Back
Top