needed

Aprilia Forum

Help Support Aprilia Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. D

    Help needed bike starts but cuts out after a few minutes

    Got a 2001 RSVR I am sure its fuel related because if I leave the bike standing it starts then cuts out again, sometimes it runs for a minute or 2 and at one point I thought it was sorted because I left it running and turned it off, but when I went to start it again it ran for about 20 secs then...
  2. A

    Contact info for Aprilia importer in Holland needed

    Hi guys, I'm searching for some contact information on the Aprilia importer in Holland. The warranty has never been activated, and this needs to be done, before any warranty-work can be initiated. I have bought the bike used (1000km), and cannot get in contact with the seller, so I don't know...
  3. D

    Help on model needed

    Just need a bit of advice on my RSV R, its got all the usual RSV R bits Ohlins, OZ wheels etc. Harris rearsets, full Harris race system. I have damaged the speedo LCD display after a fall at Portimao and wanted to replace the full instrument panel. The rev counter is white with Harris logo on...
  4. S

    Help needed please.

    Hi all, Im new to this forum and would appreciate any info you guys could give me regarding my mille. My basic problem is that when riding the bike and i indicate right the engine produces a miss fire in time with the flash of the indicator, but only on the right, but if i put the indicator on...
  5. MilleBoy82

    Fixing my sprag cluctch lads knowledge needed

    Alright lads hows it going... the time has finally come to sort this out been dodging the bullet for a long time but now its unavoidable so i was hoping i could check these part numbers out with you guys to make sure there correct before i order them, if theres any cheaper parts...
  6. R

    Left handle bar needed

    Need a left clip on for a 2000 spec rsv if anyone has one
  7. D

    Seat and subframe advice needed

    My 2001 RSVR has a single seat fitted, so need subframe, pillion seat and every thing else that goes with it (the mrs wants to come out). I am not sure which year models will fit, I believe 98-02, anyone know?
  8. rubbish1

    Help needed to fit chain connecting pin correctly...

    Does anyone know what the correct width across the chain connecting link is on a DID 525 chain???? I don't want to pinch it too much and make the link stiff. I am using a chain riviting tool. I have been told the width across the link should be 17.4mm when press fitting, before riviting it...
  9. Bigkev75

    01-02 rear seat cowl needed

    Hi there has any body got a 01-02 rear seat cowl they would like to sell in matt black if poss or has the bottom black plastic part pls pls pls
  10. M

    Advice needed.

    Hi all, I have jusy bought an 07 r model after 15 years of 4cyl sports bikes and i gotta say i love it. but i do have some teething problems any advice would be great. 1, I only got one key with the bike where can i get another without it costing the earth? 2, I have been out on it twice since...
  11. R

    Help! Velocity stacks needed.

    Guys, does anyone have a set of 57mm RSV stacks that I can buy/borrow urgently. My bike is at Griffs and we are being held up by the dreaded Italian supply system, I need to collect the bike next Friday but Griff cannot dyno it until the stacks turn up. If borrowed you are more than welcome to...
  12. V

    Help needed !!!!!!!!!!!!! - desperately for my 04 rsv 1000r

    I'm new to Italian v-twins - recently bought a RSV 1000R which had done only 8400miles - bike was going fine just made a few tweeks to the clutch and was really enjoying my bike when the following happened - symptoms are as follows: the bike won't rev past 3k - when you do - it stutters like...
  13. C

    Please help - Side Stand mod urgently needed

    Please please please could somebody help me either replace or modify my **** side stand before it falls over. Thanks alot Joe
  14. C

    Converting mille to tuono - help needed!!

    Hi all, Just bought a 99, Mille that i want to covert to straight bars. Anyone tell me whats required for the bar conversion? I know i need risers and bars but will the clutch, throttle and front brake hose reach or do i need to replace? Also struggling with the front brake lever, can...
  15. J

    Decisions. Advice needed

    Hi all I have been a quiet follower on this site for quite sometime now. I have had 2 Milles over the past few years, however after a recent engagement I have decided to sell my Mille/Tuono Rep. Still get to keep my track bike Last year I decided to turn the Mille into a Tuono as my back...
  16. C

    RSV 100R Akrapovics needed

    Anybody got a set of these beautiful exhausts that they are selling?. Give me a text or email: 07954146076 [email protected] Thanks for your help Joe
  17. C

    Artic White front mudguard needed

    Has any body got a front mudguard for a Artic White RSV1000R 2008. Mine has a slight crack. [email protected] Thanks Joe
  18. V

    rearset needed

    Hi there On my restoration which is looking awesome at the mo, i require a rearset! Has anyone got an aftermarket rearset that looks sharp. I dont want to replace the OEM gear and brake shift maybe just the rubber pegs, but do need footpegs and bracket. Have looked at acculign and woodcraft...
  19. G

    ~~~~~~~Help Needed Urgently~~~~~~~

    Good evening all I am in desperate need of some advice from those in the know. My 03 Millie has been running rough for a few months now with a backfiring into the airbox on small thottle openings which has been gradually getting worse. Throttle bodies have previously been balanced using a...
  20. Sabre

    Optimate help needed

    Unusual, this. The connector has come off my optimate lead. I can still connect it to the bike but does it matter which femail connector goes to which male connector - I guess it does. Is it possible to test with a multi meter for which is posative and which is negative?:dowhat
Back
Top