This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

issue

  1. G

    Overheating issue unresolved

    Hi everyone. This is my first post and it's not a happy one unfortunately. My brand new Tuono V4R has been overheating from day one with peak temperatures of 116c and the warning light coming on. It's back at the shop obviously, but they have not yet found a fault. Apparently all checks out...
  2. T

    Speedo and Gear Sensor issue

    Morning all, Tootled off to work quite happily this morning, then noticed halfway through journey that my gera indicator was reading at "clutch in" position - i.e unknown. Also, my speedo is reading at 0mph. Great for keeping my milage low, but not practical long term.... Pulled into petrol...
  3. B

    Neutral probs on 2011 v4r? Not a warranty issue apparently!!!!!

    Right here goes a rant:bawling I've had my v4 about 3 months and it's always been abit tricky gettin into neutral I've had a few bikes and I'm pretty sure it's not me! After all I had no probs with the apparently made of cheese gearbox on the superduke R I did 10k on! But this little bastard on...
  4. Snaggle

    Starting issue

    Lo all long time no see !! Well my Tuono is a little poorley and not sure where to start . Its a 2006 gen II . It did this last year and then cleared itself and has been fine since but this time it does not wanna play ball . When cold (ie: has not been started or tried to start )...
  5. Philly46

    Sidestand Fitment Issue

    Just fitted my Leo Vince 2-2 to the bike but not a chance the sidestand will not foul the pipework. Obligatory pictures... Sidestand... Paperwork... Bracket... Pipework... Ideas?
  6. M

    Gen 2 charging issue again

    Hi guys, Before I will spend 200 quid on stator change, please can you advice on the issue? Problem started on my way to Spain, onm a ferry queue i noticed engine temp going up to 100 C when on iddle. Only when I revved the engine up the fans would speed up and cooled the engine. I...
  7. M

    Fuelling issue at high speed

    Hiya, I have a 2003 RSVR, pictured below. I have added the following mods: - Hooked Air box - Dr Rossi Chip I reset the TPS to 0 when I added the Dr Rossi chip. At speeds of almost dead on 100-105 mph the fuelling seems to give a little bit of hesitation, like its cutting out for a split...
  8. Z

    Clutch issue!!

    Hello Gang, I am after some advice regarding my 2008 RSV.I have an issue with the clutch,when I have been for a ride the clutch lever doesnt seem to release smoothly.It makes it hard to pull away smoothly,it is also quite hard to get into neutral.The bike hasnt been used much...
  9. K

    Had an issue with V4 Tuono egine miss? Any ideas?

    I've had my new Tuono V4 R APRC for about a month now. Already have 1300 miles on the clock as well. Well, twice now, I've been riding on a warmer day (temperatures 80-85 degrees F). I parked the bike for a bit. When I restarted it both of these times, it started and then was missing out...
  10. Bigkev75

    Front wheel issue

    Hay Can any one help me on this I have just changed front forks for 05 radial Showa on my 1999 Mille I have the spacers 2.5mm behind the disc clutch side is fine but the brake disc on brake leaver side rubs on caliper eage It seems like the fork leg needs to go over towords the disc more I have...
  11. Pasper2

    Mille 2007 with Akra Cans - Cut out issue

    Hi All Recently returned to being a Mille rider :doug Its a low mileage 2007 R with twin Akra cans, the problem I am having is occasionally pulling away is that it's cutting out. Its happens when cold or warm no real consistency its almost like it catches it off cam and stalls when you go to...
  12. L

    side stand issue

    these are a pita from what ive read ? i had a ride out today and after braking hard the bike cuts out !! would start but dies after gear selected? fiddle with lever and stand and ok again? i fitted new levers yesterday so thought it must be the switch? no not that and after looking at the...
  13. T

    Coolant issue

    Long time no post. After dismantling, cleaning, and flushing through the radiators and coolant hoses on my 2000 rsvr, I was wondering; do i need to bleed anything when I refil the system? I've looked for posts relating to this, but couldn't find any, so sorry if I'm repeating a previous...
  14. S

    RSV Millie Starting issue

    Today at Mallory Park after a session my 00 Mille died. Hitting the starter button only clicked the relay. I noticed the battery connections were loose, borrowed a charger and after 30mins charge it started. However after that it never started again despite being left on charge between...
  15. C

    Freaky Clutch issue

    Hello, I recently changed the fluid for my clutch. No issues here. I dont know if this issue was present before the fluid change and I only noticed it now but... When I pull the clutch lever 30% it makes a air squirting sound like I am pushing air with some water trough a small hole and its...
  16. R

    2007 HOT *** issue!!!!

    Hi all, i went out yesterday on my new to me 07 rsv for the first proper length ride and you get a lot of heat coming up from under your legs, does anyone know if this is engine heat or exhaust heat and can i do anything about it? Cheers Rich
  17. C

    side stand issue

    hi i took the side off my millie,sprayed it up as it looked tatty!! put it back on ,the problem is now the side stand when down holding the bike up indicates the side stand is up!!! when up its indicating its down hence the engine cuts out when put into first!! what is wrong i have made sure peg...
  18. N

    Running issue

    Hi there I'm a newbie so be gentle lol I have just bought a 1999 rsv Mille with 19,000 drove 200 miles in the worst weather it rained all the way was not nice at all when I filled up with fuel and closed the cap i noticed fuel leaking from it.when I got home totally sopping wet the bike started...
  19. T

    Front brake "sticking" on issue

    After replacing the scuffed / worn down levers with a pair of new ones, I had a bit of a scary moment when the front brake "locked" on! :eek: The new levers were lubed and tested for sticking and freeness, and even the pins / brass levers that operate the hydraulics were all cleaned and lubed...
  20. deaney

    chain touching tyre issue

    hi guys can someone please advise me what to check .cos the markers on the swing arm are both set on the same marker. but i am unsure which to adjust next or which is the best way to set it right and by how much should the chain miss the tyre by my tyre is a 190 /50/17