ignition

Hello everyone I bought a Tuono 660 from a salvage auction without a key for my girlfriend and I have been racking my brain on how to bypass the user code or bypass the immobilizer so she can ride it? I found out the bike was stolen and recovered from progressive, so I reached out to...

hi well coming to the end of my rebuild and guess what? fuse B blow all the time. However, it does not blow when I disconnect the wires for the alarm (it does not have one just a loop). And if I leave them in it blows. awaiting a fuel pump which I don't think would make any difference. ive sort...

Hi there I run a quick search but nothing showed up. I'm experiencing an issue with my lock wiring. A little while ago all of a sudden mid-riding my instruments started flashing and the bike was turning on and off. I took it to the mechanic and he identified a cable from their lock wiring had...

:confused Back story: rode the bike home, all was fine, got on her to leave, running on 1 cylinder. Code check, code 33 Ignition #1 Ignition signal 1 not present. First i check that the plug wire didnt pop off like it did last month. All secure. Next I had it towed to my shop. Purchased new...

Hi all. Im after a rear ignition coil for 2008 model. Many thanks bearshead

I've done a search and I see mention of people cleaning, lubing and 'stretching the spring' inside the switch. Is it possible to carry out this fix and get into only the switch electricals to clean it etc without removing the top yoke and drilling out the anti-tamper bolt? Looking at pictures of...

Hi Guys, I want to install a USB socket for charging my phone on long journeys using Sat Nav. I have bought a unit from Fleabay that looks like it will be good - but I want to power it from an ignition live rather than a permanent live just in case. Any ideas where I will be able to connect...

Hey everyone, I'm new to Aprilia and this forum and I have what I'm sure is a stupid question, but I've been searching for the answer for the past hour to no avail. I have a 2009 Aprilia Tuono Factory and when I turn the handlebars left and turn the key in the ignition to left, it will push...

Hi Has anyone done anything with the ignition code, on the capo 1200. Dealer told me not to worry about it, but the "code" message on dash flashes all the time. Are you meant to set the code, as a one off or every time you start the bike?, it is not clear from the manual what its used for...

Just wondered if this is ever happened to anyone else??? Turned off the key on the V for today on a ride out to Whitby North Yorkshire'when I try to turn it back on it would not go to the on position, luckily for me a chap called up on his bike, said he'd fixed the similar problem on someone...

Over did washing the bike after a soggy day at brands - went back into the garage later to find the fans running full blast with the ignition off. Presuming I've got water somewhere between the engine temp sensor ant the fans. Can someone point me to where the temp sensor sits or had this...

Just a heads-up on the fail mode I just experienced. The boot anchoring the wires to my ignition switch had cracked/failed. Upshot was the wires were flexing too much with the turn of the yoke. Eventually this caused a break at a solder connection in the switch. In my case it was power to the...

hi guys ,on my 08 bol`dor the headlights come on with ignition switch is there any mod i can do to turn them off as i think the drain on the battery might be a problem when starting some day or should i just live with it ...

Hi I have a 53reg RSV (gen2) new shape and recently had the Ignition coil replaced by a mechanic friend but now there is oil leaking from where the ignition case is bolted onto the engine... where a an electrical cable enters inside to the ignition. Where can the oil come from? is it easy to...

Bit weird thing happens to my T. Last week battery went flat. Charged it and when connected back all was fine until I switched the ignition off. Few seconds after turning the key, high beam lights came on and wouldn't switch off. When I turn ignition back on everything is back to normal. Any ideas?

i have a ignition with key and petrol filler cap with same key for sale inbox me if your interested

Hi All ... I've got an '04 with a PCIII. Currently needs switching to MAP2 and a dyno session to get the PCIII where it should be. However, I have a small amount of experience and fancy playing with the ignition timing slightly. I feel a 3-5 advance might just help give some nice gains...

Mornin' all... Finished the last of the Mille refresh on Saturday - she's now sporting new rubber, running 16-43 gearing on new Renthal sprockets & chain, had a full fluid refresh (brakes, clutch, oil, coolant...) and has a new battery ready and waiting on the Oximiser :doug One small worry...

anybody have a damaged ignition barrel that has the electric housing at the base still in tact? I've just bought a lockset off ebay and the bottom is completely fecked :(

anybody have a damaged ignition barrel that still has the electric housing at the base still in tact? I've just bought a lockset off ebay and the bottom is completely fecked :(