engine

Hi everyone. Im trying to figure out a problem with my Ape and i hope that i can spark a discussion where seasoned tuono riders can maybe help me solve it. Here it goes. Bought a 2003 model Tuono 2015 summer with 35k km. Ran fine. Did the usual service (new tires, oil, filters, coolant etc)...

Full running engine ( just stator missing, you know ..... ) , 600 e. Located in Finland. Rate of euro is now low so ......

Hi, ive searched around a bit after my problem, and cant really find any good answers. So here i go: A couple of months ago my old battery went dead. So i bought a new one (cant remember brand). No cheap one though! The first days with the battery it would work out fine, and start whenever i...

Hi, wondering if any of you can recommend a good engine oil for the V4r, what oil are you lot using? My oil is low so just going to change it, also, how much oil do these things use? Haven't done a huge mileage since I got it but it seems to burn a little, not concerning me but think i'll keep a...

As per the title, I am breaking an 08 RSVR big valve engine .It has only done 1500 miles and all parts are in excellent / as new condition. Clutch plates and steels £80 370 watt stator and rotor £100 Big valve heads £200 Barrels £60 Sprag clutch £50 Immaculate magnesium valve covers £65 Let...

Hi. I am in a bit of a hurry and my aprilia dealer has said if i remove the stator engine cover i can do it without draining the oil. Just wondered if true.

As per the title, I have got 2 Gen 2 engines that have both been converted to fit a Gen 1 and run the Gen 1 electrics. The stator's have been changed and the early came covers fitted with the camera sensor, both run spot on and I will give a 30 day guarantee. Looking for £400 each. Cheers Mark

As per the title, I have got 2 Gen 2 engines that have both been converted to fit a Gen 1 and run the Gen 1 electrics. The stator's have been changed and the early came covers fitted with the camera sensor, both run spot on and I will give a 30 day guarantee. Looking for £400 each. Cheers Mark

Can anyone confirm that the engine bolt above the swing arm (120mm total length end to end) is the same on a 2000 RSV Mille and 2000 RSV Mille R, problem with Constand I ordered they say they are different lengths??

Just got my new GB Racing protection for my pride and joy

I'm refitting my engine back to frame and I am wondering what is correct procedure to srew back this bolt (see picture below)? Do I need to srew only middle bolt, or for why is there outside as well? Is there any special tool for it?

Just wondering if anyone has replaced the OEM (Marelli) engine management module, and possibly the dash, for something else, such as that available from MoTec. Mine OEM unit is being problematic at the moment, and if it turns out that it needs replacing/repairing, I am wondering whether...

Hello guys, I have a question. I have RSV1000R 2004. Can I start the engine with dashboard disconnected ? My dashboard is faulty... I am trying to start the engine now but CDI doesn't send signal to injectors to work, sparks and fuel pump work normaly. I saw a few wires that come to dash from...

Hi Guys, Recently my 04' RSV 1000R Factory has developed a weird engine noise, this weird knocking sound (like sand in the piston block) only happens at 2.5k-3k rpm, irregardless either moving or not, and accross all range of gears. I tested the engine during cold and warm engine temp, the...

Just like the title says. My 40 jet is ordered, and I'm just wondering if I should change it with the engine hot, cold, or doesn't matter. I'm guessing cold, but just to be on the safe side.... Thx

Hi there I am on the look out for an rsv engine generation 2 with head work or blue printed to purchase or rent for whats left of race season thanks for any help Payner..

Can anyone help?? The bike is over revving when warm. Starts off at a steady rev then when it gets warm starts to over rev at around 4500-5000 RPM. -And the cooling fans don't cut in when they should!?? Just changed my bike into a track tool and carried out the flaper valve modification as...

Hi, Just got back from a trip to the Nurmburg and on the way back i have an oil light on, no indicators and the engine fans don't work ?? Anyone know of an easy fix, the bike obviously gets very hot in traffic and i need indicators. Fuses are fine as is the engine oil level. Cheers Wayne

Hi I'm needing a tuono 04 reg complete engine if anyone has one or knows of one can you please let me know. Thanks.

Hi can anyone help I need to fit a new engine/ gearbox to my 04 reg tuono 1000 will all the rsv rotax engines fit like the mille 99 to 2005 and are there any mods needed.Any help will be great.Thanks