adjustment

Hi, Where is the idle adjuster on the 2004 RSV Factory, when warm it only just ticks over, nearly stalling. Thanks Rich

Hello all I have a 2003 t and I am having a very difficult time adjusting the chain and getting proper wheel alignment. the chain goes loose and then tight and so on. Does anybody know the best way to achive the perfect alignment. Any help would be greatly appriciated Thanks Bill

OK GUYS WHAT IN YOUR OPINIONS IS THE BEST TIME TO ADJUST YOUR CHAIN ?? WHEN ITS COLD OR AFTER A RUN/WARM :dunno BEEN BIKIN YEARS AND ALWAYS DONE IT COLD BUT JUST WONDERED ....

Hi guys Has anyone had to do their tappets if so how easy?:dunno Did you find they needed doing?:dunno If so how far out which way and what sort of mileage?:dunno I am sure someone out there has done them themself or paid an arm and leg to have them done but was it neccessary:confused

What effect would stifening the front suspension do for a ride? I find the front diving a fair bit under serious braking. Would it make it more stable or would I be better off leaving it to the pros?

Would anybody know if the rear brake switch is adjustable up and down? I have just fitted a pair of Harris Rearsets (amongst a number of other mods - full thread to follow), and the rear brake lights are on constantly as the Harris Lever does not but up properly to the switch contact...

I seem to getting flashed all the time when on dip, infact my dip beam seems to be brighter than full beam. I have tried adjusting the screw in the lower left hand corner anticlockwise but it does not seem to make a difference. The manual states a phillips head but on my lights is a allen key...

I don't have a paddock stand yet and my chain really needs adjusting before I go to work in the morning ... I loosened the main nut and right hand side is fine to adjust but the left just won't turn (I can unscrew the locking nut fine) do I need to push the spindle (if thats what its called)...

As everyone already knows you can adjust you the clutchlever in great detail. Asuming that you have the correct oil in your engine and your clutch system is bled you can adjust the lever to perfection. Also I read the tales of a slipping and also dragging clutches so it's hard to get it in...

Hi all. I can't seem to adjust the cable. Is it a rubber sleeve over the adjuster - I can't seem to pull this along to access the adjuster & locknut. :jack

This is my first post on the zone so be gentle with me!! I've got a 2007 Tuono and was wondering if anyone can help with a small problem? There is about half an inch play in the throttle before you get a pick up from the engine! does anyone know how to adjust this? Thanks keep up the good work

Hi New to this bike but I have located a screw on the throttle bodies which I believe to be air adjustment screws. What is the base setting for these from fully in as I think someone has played with them and does it just effect the tick over mixture or right through the range.:dunno

can anyone explain how i can lower my headlight beam as it is to high and blinding drivers:cheers

Went to adjust the chain for the first time today, opened the tool kit and no spanner to undo the spindle :rant:dowhat Trip to Halfords to get a 32mm socket and was admiring their 150 bit prof socket set. Manager turns up and says if he knocked it down to £100 would I buy it? Guess what I now...

My 2000 Mille has the forks set showing 2 rings above the top yoke (excluding the cap) on the fork stanchion. The front end feels vague into corners like i'm riding a chopper. The manual suggests 4 rings showing so i think the front is set a little too high anyway. What have you all got? Any...

Hi everyone again, Does anyone know how to adjust the idle speed on the 04/05 RSVR Factory. :confused The manual doesnt say..is it a big secret as my zx6r had a wee wheel adjuster under the left hand side fairing...im assuming its a more difficult task on this bike:jack

Alreet lads im sure i read some where that you could adjust the seat height on the mille or was dreaming, Also ive asked before and im sorry for being a dime bar but you know the adjustable Rev light- Now is this just a light or does it acctually limit the revs so for example as standard there...