Joined May 2008
379 Posts | 0+
Norfolk
Bike ran and rode beautifully before being put in storage..
Because we were having the garage demolished and rebuilt it got stored on its rear paddock stand on a slightly uneven surface for around 3 months
Now back in the nice new garage i start brushing the cobwebs off when i notice the handlebars wont go full lock without fouling the tank :angry
So i start poking around trying to figure what could be causing it, i lifted the tank up, it wasnt any harder than usual
Now, the tank will not go down again!! its a few mm proud of where it should be for reasons unknown :confused
View attachment 4747
Couple months gone by and im still no closer to figuring out exactly what the problem is or what caused it, the bike has never been crashed/dropped or anything.
I have lifted the front off the ground and done the violent shake the forks test to see if the headstock bearings are loose, there is no movement at all and they move nice and smooth from one side to the other
I have had the tank mount bracket off and checked it isnt bent
I have loosened off the subframe mounts and made damn sure they are as far back as they can be when tightened back up
There is simply no explanation for this, either the tank itself warped.. or the frame did.. or something i completely overlooked
Im used to the tank being a bugger to get back down but this is a bit worse than just a tight fit :dowhat
Please share suggestions & advice on what to do next i could really use some help on this one
Because we were having the garage demolished and rebuilt it got stored on its rear paddock stand on a slightly uneven surface for around 3 months
Now back in the nice new garage i start brushing the cobwebs off when i notice the handlebars wont go full lock without fouling the tank :angry
So i start poking around trying to figure what could be causing it, i lifted the tank up, it wasnt any harder than usual
Now, the tank will not go down again!! its a few mm proud of where it should be for reasons unknown :confused
View attachment 4747
Couple months gone by and im still no closer to figuring out exactly what the problem is or what caused it, the bike has never been crashed/dropped or anything.
I have lifted the front off the ground and done the violent shake the forks test to see if the headstock bearings are loose, there is no movement at all and they move nice and smooth from one side to the other
I have had the tank mount bracket off and checked it isnt bent
I have loosened off the subframe mounts and made damn sure they are as far back as they can be when tightened back up
There is simply no explanation for this, either the tank itself warped.. or the frame did.. or something i completely overlooked
Im used to the tank being a bugger to get back down but this is a bit worse than just a tight fit :dowhat
Please share suggestions & advice on what to do next i could really use some help on this one