starting problem

Gumenetka · Sep 3, 2012

Hi,

So I replaced the vent hose in the tank, because it was cracked, put everything back together but she won't start. Fuel pump primes, then I press the start button, fuel pump starts working, nothing else happens. After a couple of seconds of holding the start button the right dash says "No Start". I checked the tip over sensor and no luck. Is there a way to bleed the fuel system, any other ideas?

Thanks guys!

Gumenetka · Sep 4, 2012

Well, I think I will name the "No Start" dash function after me and from here after it will be called the ****** detector. While checking everything I didn't look if it is neutral while trying to start... So yeah it runs great now

turbopresh · Sep 4, 2012

haha... it should start in gear with the clutch in also

Gumenetka · Sep 5, 2012

yeah, I didn't see I was in gear, so I didn't pull the clutch...

Paul Ali · Sep 5, 2012

Easy mistake to make like having the engine kill switch off...

Carbon Kid · Sep 5, 2012

I always pull the clutch in every time when starting, plus wait a few seconds for everything to prime etc
ck

Gumenetka · Sep 6, 2012

I also wait for the pre-start stuff to go off. Not sure if it matters that much but just to be on the safe side.

Carbon Kid · Sep 6, 2012

it does matey, or the clocks will flicker and zero, my **** bike does the same thing
ck

Gumenetka · Sep 9, 2012

humm, mine never zero, I have a new battery, the brown connector mod and aftermarket starter solenoid.

Carbon Kid · Sep 9, 2012

Give it time mate haha

Search

Search

starting problem

Gumenetka

Gumenetka

turbopresh

Gumenetka

Paul Ali

Carbon Kid

Gumenetka

Carbon Kid

Gumenetka

Carbon Kid

Similar threads

New Posts