- Joined
- Jul 6, 2008
- Messages
- 97
I was changing chain and sprockets (16/44) at first i had to figure out which way round to fit talon rear sprocket as its machined thinner (-1.5mm) in the center from one side, worked out that the flat side(no inset) should go up against sprocket carrier 
otherwise sprockets would not line up properly !
but then on tightening (with torque wrench 38ibs)one of the sprocket bushings rung off on inspection looks like some of the bushings have been overtightened in the past! is this a common problem ?
otherwise sprockets would not line up properly !but then on tightening (with torque wrench 38ibs)one of the sprocket bushings rung off
on inspection looks like some of the bushings have been overtightened in the past! is this a common problem ?
