P
pointer rsv
Guest
just ordered new front and rear sprockets 15/42:devious for the bike can any one tell me the torqe settings for the nuts:thumbup
Help Support Aprilia Forum:
- Joined
- Apr 12, 2008
- Messages
- 132
- Location
- bristol
i think they are 50 nm .i use a small amount of thread lock to stop them undoing themselves as the can do.
ian
ian
P
pointer rsv
Guest
is that the same front and back?
- Joined
- Nov 23, 2007
- Messages
- 839
- Location
- Northampton
Just checked the workshop manual and it says rear wheel axle 120Nm. Haynes state 90-100 to prevent possible rear wheel bearing damage owing to excessive pressure. I always do mine at 104Nm.
The sprocket/sprocket carrier is states is 50Nm. As there's no separate mention of the front sprocket I would assume that both the nut on the front sprocket and the nuts on the rear sprocket carrier are the same. The manual states that both are 10mm threads?
Hope that helps :thumbup
The sprocket/sprocket carrier is states is 50Nm. As there's no separate mention of the front sprocket I would assume that both the nut on the front sprocket and the nuts on the rear sprocket carrier are the same. The manual states that both are 10mm threads?
Hope that helps :thumbup
P
pointer rsv
Guest
thank's :thumbup
