rsv 2001 kph to mph

Turn on the bikes electrics but don't start the engine.

Hold down the far left dash button (A?) for about 10 seconds and the numbers will start flashing
Tap the next button in (B?) to switch between mph/kph.

The numbers will keep flashing until you start the bike and ride over 10mph (roughly)

All dash functions here:

Resetting the service light
Key on
Press Lap and R for 5 seconds
Switching KM/H to MPH
Key on
Press A about 5 seconds until blinking
Press B to change unit of measurement
Press A for 5 seconds to confirm choice
V max
Uses trip odometer #1 (the odometer displayed during instantaneous speed)
To reset trip odometer #1 press R for 2 seconds
To display V max and distance of trip odometer 1 press B for 2 seconds
To reset V max press R for 2 seconds
AVS (Average Speed)
Uses trip odometer #2
Hold down B for 2 seconds and then press again
AVS is displayed along with distance of trip odometer #2
To reset both AVS and trip odometer #2 press R for 2 seconds
Redline threshold (engine off only)
Press C, release, and press again
Release C when desired RPM is reached
Battery voltage
Press D once
Setting hour
Press D twice
Press LAP until desired hour is reached
Press D to confirm
Setting minutes
Press D three times
Press LAP until desired minutes is reached
Press D to confirm
Setting °C or °F
Press D a fourth time
Press LAP to alternate units
Chronometer (Lap Timer)
V max, AVS, and trip odometer #2 no longer function in this mode
Press LAP and within 0.7 seconds press D to enter chronometer mode
To start timing press LAP and release immediately
To store a lap time press LAP
To display lap times press B
To cycle through the stored laps, press LAP
To reset memory press A and LAP for 2 seconds
To leave chronometer function press LAP and D

I know this is a old post but do the codes above work for an 03 rsv mille?

mikep561 said:

I know this is a old post but do the codes above work for an 03 rsv mille?

Click to expand...

Yup, same across all 98-03 RSV and 02-05 Tuono

HTH

Thank you brotha