Ok guys, got the new factory.......

Right guys, picked the bike up from Paul (cheers pal!!) and dropped her off in the garage, fitted optimate lead to battery and plugged it in.
*
It's a beautiful machnine!! Got a couple of wee questions, so here goes...
*
1- Paul has Pazzo levers fitted and when i pull the lever, the brake light doesn't activate. Must be the switch but can anyone tell me if they've had this and how they cleaned it up??
*
2- I'm going to raise the rear as much as possible as i like it that way and wondered how i would know when I'm at the "limit" without the bottom mount coming out completely?? Has anyone got a measurement i can take or threads showing below the locknut etc...??
*
3- Needing to get a new rear tyre (probably swap both over) and wanted to confirm a 190/55 fits without issue??
*
Cheers all.............looking forward to getting her out....those cored cans are fecking evil!! May not need the Devils on after all!!!

I have ny new 07 factory too.. got it saturday like you

I have pazzos on both my gen2's, brake light works fine, should be a little pin on the underside of the lever that actuates a microswitch.. all mechanical and easy to see..

I know there is a manual for the OE ohlins shock, I've seen it around, and I am quite sure it mentions a maximum adjustment limit.

I've run 120-70-17 and 190-55-17 on both bikes without any issue.

HTH

Andi I've got a 180 rear on mine if you want a comparison for the difference

Thanks guys, keep you posted!