new member first bike .hopefully slight issuise

Aprilia Forum

Help Support Aprilia Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Apr 30, 2014
Messages
24
Location
uk
New owner of a aprilia tuono r 2006 (7k one formor owner from new
Drove bike back everything seemed well .bike suddernly lost power and cut out . (great start)
Jumped bike and started fine .untill I removed jump lead and it cut out.
Fitted a brand new battery and left it on optimizer over night ..
Started fine and is charging great..went out for a decent run all fine next I get service message pop up with a red triangle ..after reading fault code says ..p code starter relay open curcit .odd as it starts fine any ideas(p0616)
 
Hi, welcome to the club! Hope everything works out for you! Once it does you'll love the bike!
 
Welcome to Tuono Zone,...great intro there.

Have you tried to delete the error code?If so,does it come back?
 
Give griff a ring at aprilia performance 01827 285500
he's always willng to help out and give advice.
 
Ok,...

just to clarify,...you are using the 'delete errors' option in the diagnostics to delete the Service and warning triangle?
The 'reset service' option is for removing the spanner service icon that pops up every 6200 miles,or so.You will be amazed how many get that wrong.

So,assuming you have deleted errors and the warning comes straight back,I guess there could be a fault in the wiring.I dont think there will be anything wrong with the solenoid.On the Gen2,they are pretty bulletproof.The error code is flagging up something wrong that is associated with that circuit.Could be something like a snagged,chafed or cut wire somewhere.Could even be a slightly dirty electrical connection.Would'nt take much.
FWIW,
There are no test values for the starter relay in the official wsm or service book.
 
Ok,...

just to clarify,...you are using the 'delete errors' option in the diagnostics to delete the Service and warning triangle?
The 'reset service' option is for removing the spanner service icon that pops up every 6200 miles,or so.You will be amazed how many get that wrong.

So,assuming you have deleted errors and the warning comes straight back,I guess there could be a fault in the wiring.I dont think there will be anything wrong with the solenoid.On the Gen2,they are pretty bulletproof.The error code is flagging up something wrong that is associated with that circuit.Could be something like a snagged,chafed or cut wire somewhere.Could even be a slightly dirty electrical connection.Would'nt take much.
FWIW,
There are no test values for the starter relay in the official wsm or service book.
found issuise was alarm .some ***** had wired it to wrong side of starter relay .hernce storeing as a fault
 
Take the alarm off, they're more trouble than they're worth mate.

Glad you got it sorted,enjoy.
 

New Posts

Back
Top