Need help here guys for my sprag clutch change

RolBer · Apr 17, 2009

I am just about to place my order from www.speedaway.co.uk on the parts i need for this repair on my 00 rsv mille.

I need:
1. Sprag clutch housing, do any of u know the part number?
1. Locktite 648
1. Gasket
1. Bolt for flywheel removal. Do i need this?

The sprag clutch i am going to order from here http://www.motorworks.co.uk/bmw/products/product.php?f=b&bke=bmw&q=ENA57177

Is this all i need or have i forgot something?

Garvey20031 · Apr 17, 2009

havent a clue but keep us posted, im sure one day I will be doing mine

A303 · Apr 17, 2009

That's the right sprag clutch part number - don't worry about the housing number, they'll know it.
I assume you've read up on how you need to fit the BMW sprag the 'wrong' way.
You'll need a flywheel puller (22mm RH thread) and an M8 x 100mm bolt to use as a crankshaft locking tool.
You are welcome to borrow these but i have no idea how much it would cost to post them to Norway so it may be better for you to source them locally. The puller is used on lots of old Jap trail/MX bikes and the bolt can be bought at a good engineering supplies shop.

A great guide can be found here

If you need any more help, give us a shout.

RolBer · Apr 17, 2009

Thx alot for the link.
I know some mc workshops around here, i think i can borrow that 22mm flywheel puller from one of them. I will check out local hardware stores to see if they got that lenght m8x100mm.

Kiwi_rsvr · Apr 18, 2009

Dont forget to measure the internal diameter of the sprag gear, if its not in spec you will need to replace it

AREESSMILL · Apr 18, 2009

Possible be easier and cheaper to buy a 6 inch nail and grind it down to a round tip,

buffalo · Apr 18, 2009

AREESSMILL said:
Possible be easier and cheaper to buy a 6 inch nail and grind it down to a round tip,

I used a 8mm drill, my flywheel was tight to come of so had to use a bit heat then cold water to break the bond.

RolBer · Apr 18, 2009

kiwi_rsvr said:
Dont forget to measure the internal diameter of the sprag gear, if its not in spec you will need to replace it

So in metric the id should be less then 35.07 mm ?

Search

Search

Need help here guys for my sprag clutch change

RolBer

Garvey20031

A303

RolBer

Kiwi_rsvr

AREESSMILL

buffalo

RolBer

Similar threads

New Posts