home made gasket and extension

lol
oh crap my buddy broke a bolt in my clutch and I made a home made gasket from roof material so far so good it's better than the original. Check out the pix
and tell me how ghetto my garage is. lol :doug
in Bo's ******** garage you break it you pay for it! lol


this trick seems to be working on keeping the clutch fluid clear so far(since a month)


my f'ed up gasket


and what caused it


F'ed up(drilled) master cylinder


I fixed it with a locktite nut and a grommet after popping out the original steel/rubber grommet


home made gasket from roof rubber


fit's perfect before I popped her cherry lol

the left spring is the new from the barnett clutch kit and the right one is the original after 9.5K miles.

yes sir low torqued Spring popped out and started hitting the aluminum washer. oh crap. How the heck am I suppose to torque it we can't get the Torque wrench to work with 11 NA per instructions. So my buddy tried to do it by hand and broke a bolt. I made him get it out lol anyway we replaced it and made a gasket and I put an extension on my short rod. I believe the crooked/woobly aluminum washer made the shaft spin at high speed which drilled my master and caused it to be a shorter that's why my clutch didn't push the piston further cuz it was pushed all the way which jammed it.
thanks Sprocker and we should add this to a DND- DO NOT DO list!!! don't let Bo torque your new clutch ! lol