Hello with "ignition no2 fault code"

Aprilia Forum

Help Support Aprilia Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Joined
Dec 16, 2014
Messages
2
Location
New York
Hi everyone from Sea Cliff, NY,

I love my '09 Factory which i got a sweet leftover deal on. It ran great, then the starter solenoid went after a few thousand miles. I replaced it with a $10 Yamaha one off Amazon, spooned on some Q3's and life was good until I took a weekend blast for a buddy's 50th b day. We pulled into a gas station in Virginia, fueled up, started the bikes to move away from the pumps to check the map. When we went to set off again, my Tuono ran like crap, I got the red triangle, and the diagnostic (run with bike running) put up the code for "ignition no.2 rear." I "U Hauled her home, bought a cheap used coil on eBay, same code. I bought the new Mercedes coil, threw that in last night, same code.
Any help or insights would be greatly appreciated.

Stuono
 
I thought the coils came as a front/rear pack?Have you tried swapping the front coil for the rear to see if it brings up a different code?
 
I Believe 1st gen has separate coils. Mine is one pack with both coils, one signal connector and two plug wire inputs. Thanks!
 

New Posts

Back
Top