Help Support Aprilia Forum:
- Joined
- Jul 24, 2008
- Messages
- 999
- Location
- fife
chris. ah'm no wantin tae alarm ye, but yer bikes ******...... noo ah'm probably doin masel here, but ah'll gie ye 150 greenbacks, 3 boxes o 2'' screws and 6 tubes o white silicone oot ma van, as a said ah'm dain masel a bit but if it helps ye oot,,,,,,,,lol,,,,,,,
ach yer bikes fine manni, just wind the hoor open
ach yer bikes fine manni, just wind the hoor open
- Joined
- Jul 24, 2008
- Messages
- 999
- Location
- fife
ye drive a hard bargain chris,,,,,,, aw richt seein its christmas ah'll up ma offer, tae twa strips o tinsel, a braw set o glitter baubles, oo aye, an a partridge in a pear tree lololol
- Joined
- Dec 18, 2009
- Messages
- 9
- Location
- round hill, virginia
5 mm seems like a lot to me. There should be some play at the buttons to allow for the thermal expansion between the disk and hub but not that much. Do both sides have the same amount of play? Is the amount of play the same all the way around the disk?
I had an full floating disk (13 inch diam) from PM back in the late 80's (long time ago by industry standards) that had about that much play at the outside edge and you could hear the buttons rattling at slow speeds. I have very little play on my '05 and it is about 20 deg F in my garage right now.
I had an full floating disk (13 inch diam) from PM back in the late 80's (long time ago by industry standards) that had about that much play at the outside edge and you could hear the buttons rattling at slow speeds. I have very little play on my '05 and it is about 20 deg F in my garage right now.
Similar threads
