- Joined
- Jun 21, 2008
- Messages
- 276
- Location
- LINCOLNSHIRE
Am i missing something here? I have a 2000 RSV mille with RSV titanium chip and end can. I've tried 2 separate chips from Dr Rossi but both of them create a flashing 'EFI' message on the dash. I handled them both like eggshells and put them both in as per the instructions, but the ECU appears not to read their pressence? The RSV titanium works if i put it back in, and the bike runs with no probs. If i put the standard A63 back in, the ECU wont read that either although this may be cos the wires have been cut as per the instructions.
When i try to set the TPS with the Rossi chip, it wont show any movement on the dash from +1 despite rotating it as far as it will go both ways.
I cant work it out and need some advice from someone who's had the same prob.
The 'protection board' is not present in any of the chips.
The Dr Rossi chips are the 'V60 Evolution open filter & exhaust' variety.
I must be doing something wrong as i'm sure both chips are ok!!!:dunno:dunno:dunno
When i try to set the TPS with the Rossi chip, it wont show any movement on the dash from +1 despite rotating it as far as it will go both ways.
I cant work it out and need some advice from someone who's had the same prob.
The 'protection board' is not present in any of the chips.
The Dr Rossi chips are the 'V60 Evolution open filter & exhaust' variety.
I must be doing something wrong as i'm sure both chips are ok!!!:dunno:dunno:dunno