The lower right hand side belly Pan has been damaged by exhaust heat. I found that the spacer pin on the bottom of the Akropovic exhaust was remove. I welded a new spacer pin below the exhaust to maintain a reasonable spread distance between exhaust and belly pan bottom.
There is a fair gap distance between the exhaust and panel at the top and bottom but the front bottom panel corner remains too close for my peace of mind.
I am now snookered and will need to profile a better gap from the body panel directly.
Any ideas please.
B
There is a fair gap distance between the exhaust and panel at the top and bottom but the front bottom panel corner remains too close for my peace of mind.
I am now snookered and will need to profile a better gap from the body panel directly.
Any ideas please.
B
