Joined Oct 2008
34 Posts | 0+
East Anglia UK
Looking for some advice/reassurance here guys... I fitted my nice new ASV levers over the weekend :doug but am a bit concerned that I may not have re-seated the replacement plunger/pin errrr thingys properly 
I followed the instructions to the letter - obviously :biggrin - but I'm just concerned that although the pin(s) sit in a recess in the lever(s) itself all that seems to hold the other end in place in the actual master cylinder is a rubber boot :confused... I tried and tried to find a hole - ooo err missus :devious - for the pin to sit in actually in the cylinders but without success :dunno
Any thoughts/advice :confused
I followed the instructions to the letter - obviously :biggrin - but I'm just concerned that although the pin(s) sit in a recess in the lever(s) itself all that seems to hold the other end in place in the actual master cylinder is a rubber boot :confused... I tried and tried to find a hole - ooo err missus :devious - for the pin to sit in actually in the cylinders but without success :dunno
Any thoughts/advice :confused
