sync

How do I do this myself? What equipment is needed? Thanks Mike

I have 57mm TB's on an O1 RSVR (Gen 1 ) with hooked airbox and dual sided system - chip to match . The chip is twin map.... Map 2 I intend setting 3.5% ( track use only) Is there any merit in using a different value for the equivalent Map 1 ( wet tune, again, track use only )...? Grtzz....!

hello im trying to balance my throttle bodies with a carbtune but cant get them to match rear seems good but front is a bit low and dosnt seem very stable has anyone had the same problem ?

I know there are plenty of threads about the internet on this topic, but as it's my first time doing this on the millono i figured i'd atleast explain what i've done to achieve what i believe should be accurately sync'd throttle bodies and CO trims in reasonable to good tune... I'd been...

Hi quick question too the knowledgelble folk on the forum , started to check my TB's and trim pots setting with my gas analyser on my Aprilia rsv 2002 57mm edwards throttle bodies , via the two testing points on the headers ( blanking screws removed ) and noticed the rear cylinder was rich but...

Just been balancing the throttle bodies. After setting them level I tried the throttle at various positions and the levels were fluctuating quite a lot. Is this normal? I expected the levels to stay fairly even. Thinking of just setting the co2 instead using a gas tester. Any advice?

Don't want to start a long complicated post. Just want to know once the sync tool is connected. Do I get front and rear exactly the same ie level, or is one meant to read higher than the other & if so which one is higher ? Finding the description in the manual confusing. Thanks in advance

Lads I have been planning to get the old lady to CO/sync maintenance, however, i have access to carbtune. On my older bikes i had always taken care of the sync my self, but Mille is new to me in this way. Is the AXONE required or do i get satisfactory result with Carbtune? Is there vacuum ports...

Hi, I purchased and installed a eprom from dr.rossi,followed the instructions(but not cut the wire) but the bike is very rough at low revs and sometimes dieing on me. I suspect that the TB sync is no good. Is it possible to adj the TBs without any special equitment so it runs more smoothy? One...