stuck

Hi All, I'm new to the community and proudly own a 2004 RSVR Factory, 2002 Mille R and I'm in the middle of restoring a 1996 RS250 Biaggi replica. I'm having an issue with the 2004 RSV factory and wonder if any of you experts can help. It's been of the road for 1 year and battery ran flat...

02 RSV Mille R........Stuck in neutral........engine won't start.....power comes on.....hitting starter makes clicking sound under the seat .....shift lever wont budge.....did an onboard diagnostic and it first came up with "11" and checked camshaft sensor.....few minutes later I rechecked it...

Hey everyone, I'm new to Aprilia and this forum and I have what I'm sure is a stupid question, but I've been searching for the answer for the past hour to no avail. I have a 2009 Aprilia Tuono Factory and when I turn the handlebars left and turn the key in the ignition to left, it will push...

Hi gang, Has anyone else ever gotten their petrol tank stuck in the raised position? the first time I lifted it(remove the two bolts beneath the triple and lift, the lower lip of the tank snagged a bit on the bottom of the triple(near the ignition). I managed to squeeze it out but squeezing it...

i recently changed batterys and lost mileage and now it is stuck on kilometers how do i reset it.any tricks

Did the oil change on the RSV only to get as far as the drain plug on the engine casing. Which had a round hole where the hexagonal one should have been. I've tried the correct hex key and it just spins. Which doesn't fill me with confidence and probably means the last oil change was only...

Hi everybody, just joined the forum and im after a little advice. Ive got a 2000 mille, crackin bike but im too fat/old/short to reach the bars comfortably. im in the process of fitting raised bars but when i tried to undo the top yoke nut, the ring nuts under the yoke turned with it. anyway...

Hi all, it's MarkJ here, fancied a name change after the server went tits up :( I'm trying to get the hugger off the swingarm but it's having none of it, I haven't managed to get any of the four bolts off because it felt as though I was starting to ruin the head (these 3mm hex bolts are...