This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

rpm

  1. L

    rpm from what

    Hi does anyone know how the rpm gets it information, have read that it does a self check which seems to surgest its electronic, so is it off the coils or flywheel sencor etc... many thanks
  2. C

    No power over 3-4000rpm urgent fault 2008 tuono r

    Hi every one... I have just purchased a 2008 tuono 1000r it's running bad like not pulling after 3000-4000rpm then a quick blip of power then nothing again. Managed to drive it home about 30 mile like that not to bad in 6th gear as it was going like 60mpg. I knew it had a fault it was described...
  3. B

    RPM needle

    Should it be bounzing when I connect the second battery terminal
  4. B

    04 RSVR won't idle below 2,000 rpm

    Hello, I had hoped my first post wouldn't be trouble related but unfortunately my just purchased RSV won't idle below 2,000 rpm. I just picked the bike up yesterday and it stalled out as I was leaving the shop where I bought it. I started it again, rode a few feet, and it was sputtering and...
  5. R

    KPH and RPM keeps resetting

    Hi there, I'm the new owner of a 2000 RSV Mille and I have a dashboard that resets itself every time the bike is switched off. The clocks are in KPH and the RPM resets to 6000 RPM, I know how to change these things but every time I turn the bike off, even for a few minutes it's back to KPH and...
  6. A

    vibration on 6000 rpm and up.

    hi my friend.i am a greek and I have a tuono 1000 2008 model.i have a problem with my dear moto.when open throtle from low speed down from 6000 rpm I heve vibration to my foot. replace bearing wheel,check screws motor,replace sprocket and chain to supersprox front rear conversion 520 and chain...
  7. Yatesy

    Flat spot/sticky RPM

    Hi, just wondering if anyone else has noticed a problem or experience the same as me. When revving it hits a sort of flat spot around 2k rpm. The needle looks as though its sticking but can't see any problems with that. It's a 2005 rsvr factory, map 2 mivv end cans. It hasn't caused any...
  8. R

    Low voltage at RPM

    Morning all, Bike has been a little reluctant to start with the colder weather, starter seeming to run out of speed too quick. Expected it to be battery related but figured I would check the voltages prior to getting a new battery (from the paperwork I can see this battery has been in 8 years)...
  9. D

    5000-6000 rpm hesitation

    Guys, I have a track day at Snetterton booked for Monday the 2nd and need some advice. I had the TBs set up by the lads visiting essex hoping it would fix the hesitation my 2002 Mille gets roughly between 5000-6000rpm but it doesnt seem to have fixed it although it fuels perfect now the rest...
  10. BB1000

    miss fire at 2000 rpm

    seems like a miss fire at 2 k rpm . runs ok after that ....all vacuum hoses seem ok any ideas peeps
  11. J

    Help - high rpm misfire

    The ever reliable 2000 Mille developed a sudden misfire above 7K rpm only. Has always run great before. It has a Factory Pro chip and a Leo pipe. I pulled the plugs and the rears were gas fouled, while the front looked great. One of the rear cylinder spark plug boots fell off in my hand, so I...
  12. Q

    MAX RPM in gen 1 RSV/TUONO/FALCO

    I have a discussion in the spanish forum about this. My bike cuts off in 10500 rpm and some people says that cuts in10750rpmm and some others says that have an eprom that cuts over 11000 pulling and pulling. But I think that the maximun RPM is controlled by the EPROM, is that right? I have a...
  13. mattblack1

    Mph at 7000 rpm

    Evening campers. What Mph does our bikes do at 7000 rpm. Got a mate who's doing some gearing comparisons but he's never had a twin.
  14. fizzydx

    How is the top speed limited? back wheel rotation or engine rpm?

    As the tittle says really, i own a Tuono R Gen 2 and would like to know what the top speed is limited to, and is this limited by engine rpm or rear wheel rotation, or something else, if it's rpm, what rpm is the limit and in what gear, the reason i ask is because at the moment i have 15/40...
  15. H

    RSVR 08 - EFI and oil light 2500-3000RPM on start???????

    Guys This has happened a few times now to my RSVR 08.... On starting the oil light stays on and the EFI warning light comes on. The bike runs rough (1 cylinder?) and will only rev to and bounces around 2500-3000rpm. this clears after about 2-8 seconds. There is oil in it and Griff replaced...
  16. RSVMilleR1

    Help! RSV wont rev over 7000 ish rpm!!

    HELP. Firstly the spec. Std except derestricted (cone in std silencer removed, wire snipped , bung removed) plus 57mm throttle bodies with std airbox and k & n. Now i started using her today having been off the road for bits and pieces over winter - no engine work though - and she wont rev...
  17. S

    Question about Sprocket Size and Cruising RPM

    Hello, I have a 2002 RSVR with stock gearing. I'm about to do a 520 conversion and change the sprocket size on my RSV. On my other bikes I usually drop a tooth on the front but after reading several posts here I see 16/44 is suggested frequently. -1/+2 is a larger jump than I usually do on...
  18. sergi75

    JERKINESS BETWEEN 3-4k RPM

    I had this problem last May just after Southerncross fitted a renegade airbox mod. According to them, it had nothing to do. The problem was solved after fitting a Dr Rossi chip, southerncross also fit a new Throttle body revision kit, part number AP0281241 and balance TB. 3 weeks ago this...
  19. P

    Cutting cut @ 6000 rpm

    Mille 02, like hitting rev limiter, no lights or codes on dash split second, happens once or twice a ride, any thoughts??
  20. J

    Below 3k rpm flatspot?

    Hi all, getting used to my bike now and while I admit I still need to fine tune the chain adjustment and throttle cable slack, the bike seems very kind of fidgety and unwilling to ride at under 3k. So this means slow junctions and roundabouts in 2nd mainly, it seems to be much happier on the...