rod

Lads, can any one tell me were the petrol tank stay rod is positioned in the bike when not in use, a photo would be great. Leslie

Hi, could anyone tell me a shift rod length for an Aprilia rsv factory with Gille rearsetts running a race shift.The bike is in IoM I would like to take quickshifter with me to tt and fit it whilst there. Many thanks Richard.

When I start the bike the clutch rod gets sucked inwards by the diaphragm vaccume when I try to push the pushrods in I can't also it won't return back out is this normal I don't want to fit the new slave until I understand what's going on

hi i am in the process of fitting a aftermarket slave fluid flush ect. i noticed my push rod on the clutch moves in when the bikes started, but does not retun until i pull it outwards after i turn the bike off. i know little if anything about these but i thought it shoulld stay out and only...

Need one of these for my 02 mille but can't find them for sale anywhere, not even on Ebay . Has anyone got a spare, new or old or know whereabouts of who will.

has any one got one of these for sale or know where to get them in the UK Cheers Mark

Gilles shift rod is 150mm in length so no chance of accommodating said sensor so going to need one around 100mm but I can't find owt. This is all for a 2003 Gen1. Ideas gentlemen?

while rebuilding my street mille i've found one of my con rod bushings (not the bearing, but the wrist pin bushing) a little scored. now i'd like to change them both but i haven't found them, just the con rod. now i can make them, too but i don't know the material they're made of. i know there's...

hi Guys, my dealer told me recently when i went in to but oil/air filters, brake pads etc, to check and grease the needle bearings in the rear suspension in the swingarm/connecting rod tied together by the dog bones. The areas where the bearings are housed are seen here: Striped the...

hi has anybody got a petrol tank prop rod thingy they want to sell me for a gen 1 mille, never got one with my bike and im fed up of using a screwdriver to hold it up when im working on the bike

Just installing the shiny new levers I'd ordered, then encountered a problem On the clutch side there is a brass push rod comprising of a threaded rod, a barrel and a grub screw. Removed the grub screw, but can I buggery get the rod out, I've now managed to chew the slotted end up for crewing...

Just installing the shiny new levers I'd ordered, then encountered a problem On the clutch side there is a brass push rod comprising of a threaded rod, a barrel and a grub screw. Removed the grub screw, but can I buggery get the rod out, I've now managed to chew the slotted end up for crewing...

Hi there has any one got a clutch lever plus the rod for a 99-03 Mille

Pulled my bike out of the garage today and it just collapsed at the rear!! :mad: Further inspection found it was the rear suspension connecting rod had split down the length. Anyone else had this? Lucky for me it wasn't mid corner!!!

Shifter Rod/Shaft correct me if I'm wrong mine is like a high RPM drill bit nowadays. lol so would an 03 Mille Shifter Rod fit my 2000 Mille? thanks I think I need to change it along with that bearing which is prolly causing the "drill effect" thanks