push

Hi all I am trying to push the rear brake pistons back but I am struggling to get them both back when one goes back the other pops back out. One of the plastic inner parts has also broke with my efforts will this be a problem long term. Both pistons move but I can't get them both out far enough...

hi i am in the process of fitting a aftermarket slave fluid flush ect. i noticed my push rod on the clutch moves in when the bikes started, but does not retun until i pull it outwards after i turn the bike off. i know little if anything about these but i thought it shoulld stay out and only...

has any one got one of these for sale or know where to get them in the UK Cheers Mark

Bought a used push-type quickshifter for my Gen 1 Tuono and tried ftting it today but discovered that it's too short to fit to my Aprilia Performance rearsets :banghead Anybody got around this? :dunno

Just installing the shiny new levers I'd ordered, then encountered a problem On the clutch side there is a brass push rod comprising of a threaded rod, a barrel and a grub screw. Removed the grub screw, but can I buggery get the rod out, I've now managed to chew the slotted end up for crewing...

Just installing the shiny new levers I'd ordered, then encountered a problem On the clutch side there is a brass push rod comprising of a threaded rod, a barrel and a grub screw. Removed the grub screw, but can I buggery get the rod out, I've now managed to chew the slotted end up for crewing...

****** italian *****! i will love you again tomorrow but today i want to put light to your fuel and baske in the warmth of your demise...... ok chaps without pouring though old threads whats the most likely cause of the t cutting out and comming up with the triangle of death and then also a...