position

Greetings. '09 RSVR. Trying to figure out how to get it into diagnostic mode so I can check/reset my TPS. I've tried searching but apparently can't search on just 3 letters (TPS). :( The couple of posts I've found say to short a two-pin connector in the rear seat area but have also seen...

Hi,:( Is there any way of checking the crank position sensor ? I have lost the spark to all plugs and the sensor is no longer available cannot source a new one anywhere. Your help would be much appreciated. Cheers Harry

Hi guys as per the title I'm trying to install a Koso gear position indicator on my 2007 Gen 2 Tuono R, doing a search I discovered some people have successfully done this but mine is just a random number generator, I've picked up the speedo pulse from the rear wheel sensor and connected to one...

Rewinding a couple of months.... I got a nice surprise when wheeling the bike out for the first time this year. The front face of the oil tank took a lot of stonechips and subsequently has suffered the most horrific bubbling rust in a way only the finest Italian metal can do. I was gonna...

Hi All. I have a 2005 Aprilia Tuono. I need to know how to check if my TPS is set correctly. Cold start is fine, when it reaches 85 Deg C all is ok. I then go ride the bike and about 10 to 15 min into my ride I then experience the following. When I stop at a traffic light the bike idle is...

Hello, looking for some help/advice, I have a problem with a 04 mille with fault code 44 showing ,which is the stepper motor no signal, however the bike runs and starts badly, is unwilling to rev beyond 4500 without cutting out completely which leads me to think it is in a restricted mode, the...

Aup All, Has anyone dropped the forks through the yokes? I was wondering if it helped with the slightly vague feeling from the front and also with turning in speed? If so how much have you dropped them by and has it had an effect (positive or negative) anywhere else? (i.e, stability, body...

Anyone got a good condition early style 1 of these knocking about with the off/sidelight/headlight 3 position lightswitch and the indicator button where it should be? It has a black 9 pin square plug.............

Hi everyone I've had my RSV1000r Factory for a few weeks and absolutely love it:inlove However, my rear brake works, as opposed to most posts I have read about the rear brakes on these. (I think this is possibly due to the fact it has Sato rearsets, which seem to alleviate the problem) The...

hi guys just fitted healtech gipro gear postion indicator to 08 tuono , works fine quite easy to fit no more searching for 7th gear or not knowing ur only in 5th doh , also did quick action throttle mod cost £10 for bits and took 30mins to do hey it actually works to :thumbup

Hello all. I was hoping to get some comments and opinions on the Tuono's seating position. I'm in the market for a new bike, (to me anyway) and the Tuono is the only bike I haven't had a chance to even sit on. I attended the Toronto Motorcycle show this afternoon and had a chance to sit on a...

I made the mistake of sitting on a ktm rc8 which was like an armchair.. well at least a vfr750. Got me thinking whether raising the bars and a little more leg room would be possible on the rsv. I know falco bars can be fitted, anybody done this? Does it make enough difference to be worthwhile...

Okay I've got the right tools now.........but how do I lock the flywheel so that I can undo the relevant bolts ?:roll

Hi everybody. Before I start I'd just like to say I haven't had my '08 RSVR long and I'm still learning so forgive me if this is a stupid question but I noticed in certain light you can see in the top left section of the speedo console etc, where the lap indicator is, the word "GEAR" is visible...