pin

Hi, I have replaced my levers and they came with new clutch pins. So i have a good condtion one for sale. I have it on ebay but open to offers to the forum. I was asking £15 in p&p. Thanks Chris This was heated up and came apart very easy so no damage to tiny lock screw or the end of the pin

Would anyone know where I can get the aprilia tuono clutch lever actuating pin and barrel from in the UK. Hopefully not AF1 as it is going to cost about £50 to get it from the states. It might be cheaper going to an engineers workshop and getting them to make one out of titanium. Chhers

hi does anyone know,if there is an alternative clip to fit the pin that goes through the rear pads.my pin is fine after changing pads but the clip looks worn with rust and a little weak.i dont want to pay 17quid for a replacement.cheers in advance

Taking my 08 Factory apart for a full winter check as the bike is new to me. now on Ohlins forks and found the brass pin from the rebound adjuster is missing.. anyone have a spare or any dealers/breakers out there with a smashed set of ohlins forks, this little part would be fine stuck...

Hello guys Anyone have a set of these spare? I know someone made a batch of them on one of the forums , and theres none on ebay before anyone says haha Cheers

Hi all, sorry for the poor thread title but I'm not sure what it's called. On my pillion seat hump, the pin which goes into the locking mechanism has fallen out and I don't have a loose spare which means the seat hump can't be held down :( The part in question is circled here: (I don't think...

Hi guys, got myself a new Eprom and managed to break off a pin, not the full lenght but the slim tip of it. Are there any chances to repair it? Here's a pic that shows where exactly i broke it http://oi49.tinypic.com/2d2hksj.jpg Stupidity at its finest...:angry And before I forget to...

Got my new exhaust and chip today! Not fitted as was too lazy earlier. I have noticed that one of the pins on the ecu chip has broke off though. Any ideas on how to sort that out?

Replacing a lever and have somewhat butchered the other one trying to get it out (and failed miserably!). :banghead

Does anyone know what the correct width across the chain connecting link is on a DID 525 chain???? I don't want to pinch it too much and make the link stiff. I am using a chain riviting tool. I have been told the width across the link should be 17.4mm when press fitting, before riviting it...

Does anyone know where I can buy the bits below?

Hi all sorry for the vague title i have a set of after market levers and while the brake lever was a doddle to fit the clutch lever is a pig... the push pin (if this is what it is called) has a small grub screw holding it in place on the lever, and unfortunatly on my bike 7 years of crap have...

Hello, i have a 2002 RSV Mille R, what is this "pin 16 mod"