needed

Hello chaps and ladies, I have a 99 rsv and one of the ht leads looks a bit crap, a friend of mine gave me a roll of silicone ht lead, it has a carbon inner, he says it will work fine if I screw it in same as is now, i trust him on most things but not sure on this one, can someone with more...

Looking for a nice exhaust can and link pipe for my 2003 Tuono.

Hi I own a Caponord ETV1000 which I cannot get to run it has been it a local bike garage for 5 months now and he cannot find the problem So if there are any Guru's in the Glasgow area I would appreciate some help if I do not get this sorted out I have been offered £1200 at a breakers but the...

Hi all, The Tuono/rsv4 Factory mongrel is still breathing. But now it seems to have stripped its exhaust servo gearing, does anybody here have the servo unit they could sell me? Ta all, Gav

Hi guys, my 05 factory still refuses to turn over on the button. I was wondering whether if the fuel pump was at fault, would the ECU prevent current getting to the starter & ignition circuits. All wiring and switches all got a clean bill of health & were bypassed temporarily. Dash shows fault...

Sent from my iPhone using Tapatalk

Hi guys Hoping someone can help i need to try and find a dogbone for the 02 mille <133mm>. Every aprilia site i go on they cant get one ,i was looking for the complete set with rollers and all the trimmings but now will just take the dogbone by itself and buy bits seperately. If anyone knows...

So I have a problem with the dealer I purchased my new 2016 1100 factory from. They unfortunately registered my first name wrong on both the reg document and aprilias warranty site. Now I only spotted this when the reg doc came back and went down to the shop to get it sorted. Salesman...

Hi all new stator and reg/rec fitted but bike wont start although it will fire every now and then. disconnect the reg/rec any side and the bike fires up fine....... any ideas???????

So I'm new to V-twin and rode one for the first time today. Wow what a bike. Now I know they seem to sound knock and clunky. But it's bloody unnerving for someone with no knowledge of a good one and a bad one. The one I am possibly getting also judders/vibrates when you get on the throttle...

Hi, help needed, I need to find a left side engine cover for a Factory RSV1000R. Have tried R&G directly and I am still awaiting a delivery date for this cover. Yesterday I was informed (6 weeks on) that they still havent a delivery date!! I have already missed one race this season and dont want...

Hi All, Proper stupid question - When you turn your ignition on and it goes through all the normal set up stuff and then it's ready to start do you: A - Just press the black button and it fires up B - Sometimes have to press the red button first before the black one works I think my switch...

I Have a 02 rsv Millie, I got start the other day nothing comes on like battery is dead but the batter is new and is fully charge. So I connect to car then it on, but when tries to start all hear is a winning noise what could it be?

linked as a favour to gabro WTB IGen RSV/Tuono/Falco eprom doughterboards

I am looking for a used and fully functioning fuel tank for my RSV Mille 1999 to buy. Ideally black however due to them being rare... Hopefully someone, somewhere..Many Thanks.

Hi guys! I recently bought a 2005 Gen 1 Tuono Factory which I have spent the past five months renovating, the bike having had a few hard knocks from its last two owners! This Sunday I take the bike for its first Breakfast Run!!! In this regard, I have been searching the 'net for an...

Hi I am currently looking for some bits for my bike Top Yoke (Ohlins 51mm Preferably) Rear Brake lever Front nose Fairing. Possibly a few other bits along the way. Please let me know

All, I need some help/advice. I'm currently in Switzerland on day 2 of 7, having just blasted down the B500 from Baden-Baden. Unfortunately today, my '07 Tuono suddenly decided to start, sounding as though the battery was completely flat (didn't even turn over) It was red hot (almost constantly...

Hi guys I am after a pair of Showa stanchions / fork tubes to fit Gen1 2003 Tuono. My fork seals started leaking recently. Some enthusiastic stopping action at Rockingham might have helped, but it’s probably down to gentle pitting that starts to appear on the stanchions. My question is are...

Hi guys and girls I need to source a new stator for my 04 plate factory anyone recommend were aprillia genuine part is way to pricey Any help much appreciated Cheers Paul