length

Anyone know what the centre to center distance of the Conrod (Engine Conrod) is? Or does anyone know who makes after market rods? Thanks :thumbup

Can anyone confirm that the engine bolt above the swing arm (120mm total length end to end) is the same on a 2000 RSV Mille and 2000 RSV Mille R, problem with Constand I ordered they say they are different lengths??

Hi all, Just looking to see if anyone knows the length and gauge of the cable from the starter solenoid to starter motor. I've done the wiring mod to ease starting problems (it worked a treat!) but now I'm cooking the solenoid-motor cable every time I start up. I don't want to keep abusing it...

In as good as new condition, best on the market i think.........cost approx £160-£180m a set these days! £120 + post (Jaseyb has pm'd about these so will have first refusal)

Ok, I know there are a million posts on here about this, but i'm tired and can't find what i'm looking for so, my question is, if i put a 16 tooth front sprocket on my 52 plate Mille, will i have to shorten or replace the chain, and also, is it woth doing? there that's it, any (positive) input...

does anyone know the length of the original 02 can? the one in my avatar. Im not able to measure mine as at work i want to get a 450 mm can and want to know if that's same longer or shorter than the original. Im guessing its shorter but just want to check first. thanks

Was sitting thinking about radial calipers and how to get them onto a Tuono... I thought Hmmmmm Superduke... they're 54mm at top and 60mm bottom. What's the Tuoldo ? The easy answer is of course, Ohlins... but DAMN they're not cheap.

Hi there, I need some help with something. I'm fitting a öhlins rear shock on my 03 and want to extend it more compared to the old one to increase riding height. How much can I extend it? Of course it has to fit, but are there any considerations about the linkage. Does there have to be a...

I would appreciate a bit of advice about replacing my chain please as it's a job I've never done before :confused I have a brand new DID chain to go on with a 44T rear sprocket. I also have the choice of either a 15T or 16T front sprocket. I've currently got the 16/44 combo on with a knackered...

Has anyone adjusted this, mine is was 311mm and going by the book it can be adjusted to 317mm Apart from seat height will this make the bike turn in quicker :dunno cheers guys

Ok took the bike out and still feel its lacking a bit of zip..its got 15t front & 41rear..any ideas how big i can go on the rear with the standard chain length?? Or do i just need to get used to riding it..(was riding a zx636r) ?? :dunno

Is there anyone with an 02 that has pillion footpegs fitted ( or to hand ) do me a favour and measure the length of them? Or if they're the same for previous models :dunno Might be taking a pillion on the back at some stage but didn't get any pillion pegs with mine as it's got the twin...

Please could anybody tell me how easy, or not, it is to adjust a chain length, im assuming you need a chain splitter, are there anyother tools required, or am I best just taking it to shop for saftey reasons etc. Thanks all.:dowhat