grease

Afternoon gents, ive just fitted a new stator to the bike and i would like to put high temp grease in the block connector to the reg/rec , anybody know where i can get some? I also re routed the cable, rather than going through the middle of the v as fitted at the factory, was loads easier and...

I have a 2008 rsv, want to grease the suspension links. The exhaust link pipe does not allow the extraction of front suspension link bolt. Question is it posible to remove the exhaust without undoing a header from the engine? If I have too undo an exhaust at the ex flange which is better front...

Does anyone bother with grease on the backs of the pads in the Brembo calipers? Note if I do grease them, it will be proper brake grease and not copper grease. I know the potential pitfalls of using copper grease, cheers.

Can someone please recommend the right grease for the front and rear axles? I have my wheels off ready to have new tyres fitted and noticed the grease looked dry and carbon type. Thanks

Changed the bearings the other day they were well gone , went out for a couple hours blast after and got home to see fluid all down the left side ?? Thought I had a coolant leak but have come to the cunclusion it was all the grease i shoved on the new bearings that melted . I only put multi...

I plan to grease the dogbone needle bearings at the weekend. Does onyone know if the 3 in 1 white lithium grease in aerosol form would be suitable. halfords sell it for around £5 a tin. if not, can someone suggest an alternative which is readily available off the shelf. Thanks Porgie

I remember sometime ago probably on another Forum site I read a thread about why the clutch fluid went black so quickly. Apart from the odd rouge answer the general conclusion was that it was the clutch seal braking down and being absorbed into the system. The simple remedy was to sear the...

I understand is one of the few lubricants to use with caliper pistons but in another thread here, someone said it damages the rubber seals. In the copper grease tube I have, it's specifically indicated for calipers pistons so I'm a bit confused now :dunno

Is this good enough to use when I strip my swing and and replace all the bearings. Also on the wheels as well when I reassemble them? http://www.motoworlduk.co.uk/grease.html