diag

Hello all I'm having a issue with my Rsv mille 02. Just took her out and noticed some backfiring and boggy low end (followed by the EFI on dash flashing. I have got the diagnostic code 35 but am struggling to see what this could be. Any help would be greatly appreciated

Hi guys This might have been asked a thousand times already but I've searched all over and can't find the answer I need to get into the diag or service mode or whatever it's called so I can reprogram a new key if that's even possible? I have tried pushing the lap/high beam and turning...

Hi everyone, just bought my second mille, my first was a 2001 r and I never had a single issue. After a couple of years off of a bike I've finally managed to pick up another one. At first everything was fine I used the bike for about a week with no problems then after leaving it for a few weeks...

Hello all, just finished rebuilding a mille I brought off ebay and I just noticed the diag 1 message pop up on the right hand dash. I've read a few posts re tps sensor and data tool issue's. After looking at my bike I've noticed the data tool has been removed I'm confused and need help, what...

Where is the diag port on a 2001 rsv and what sort of port is it Thanks Guys

Hi guys, i could do with some help! I am trying to set my TP-0, although my diag wires dont appear to be doing anything. I have removed the right vent pannel, found the 2 disconnected wires, connected them, unscrewed the fast idle, turned on ignition and only standard readings displayed on dash...

Hi everyone, this is my first post and like most new members it is regarding a drama with the bike. I recently purchased a 2002 RSV Mille it is my first bike and on the handful of times I have ridden it I love it and its noise! However, I went to start it the other day and it tried to fire...

hi guys, im a new member and could do with picking your brains! i stripped my 98 mille last winter down to the chassis and engine and rebuilt it from there, everythings great except its showing up the diag codes continually flicking from 0 to 1. runs perfect and doesn't miss a beat. any ideas...

this is what is coming up at the moment !? :dunno i still havnt fitted the Dr Rossi chip in as its booked in for Sat !! :thumbup

I get the Diagnostic error codes 11 and 12 on my 2000 Aprilia Mille RSV. I recently installed a new motor in it and checked the both drivehaft and camshaft sensors they both read 240 ohms which is good according to the specs. The cable to the ECU is also fine however when I try to start my bike...

Hi, i have a 99 mille which i have only owned a short while, today when warming the bike up it suddenly cut out. I went back to the bike and it just turned over and over but will not fire up, it has put up "diag" and underneath that "1" in the right hand display. The left display looks normal...

Jumped started the bike as the battery is knackered, and it fired up right away, after being stood for roughly 4 months due to crash, one of the radiators starts leaking so I need a new rad, But it wouldn't idle, if its not started it reads -1, once its started it reads either 0 or 1, and I...

Hi, Hoping someone can help me here... Keep getting a DIAG 1 fault on the instrument panel. Only seems to happen after 5 miles or so of riding and then after grabbing a handfull of throttle. Don't know if it could be temperature related not sure, but when it happens the spark is obviously...

Hi All, Stripped the bike down at the weekend to swap subframes as mine only had a single seater item...i took the battery off so knew the clocks would reset but it wont start and comes up with DIAG -1 on the read out.....:dunno The non starting may possibly be the battery ...it turns over...

Right Chaps! Need your help here! I've just recently fitted the race air kit, with a chip to match, however, once reconnected the ECU, The fuel pump dose not engage! and the EFI display flashes then produces a DIAG -1 message! Being luckily enough to have two Mille R's I swapped the other ECU...

Hi, I have got 04' APRILIA RSV 1000 and there is a small problem with that motorbike. Below 3 000 rpm the engine stops. When there is more than 3 000 rpm the engine runs smoothly. There is no problem with starting the engine. When my bike is in DIAGNOSTIC mode on the screen is dispalyed...