connecting

hi.nobody knows how many newton tightening the rods to crankshaft?

Hi just joined the forum apart from a fuel small snags I love my tuono but its irritating to ride the bike n the tacho could be 4000 rpm of actual engine rpm if you reconnect a new battery the needle goes tick tick tick jerking as it goes n settles approx 1500-2000 Rpm of its last rezt...

hi Guys, my dealer told me recently when i went in to but oil/air filters, brake pads etc, to check and grease the needle bearings in the rear suspension in the swingarm/connecting rod tied together by the dog bones. The areas where the bearings are housed are seen here: Striped the...

On a 00' Mille.....tonight I went out with the laptop and the cable, now according to what I've on their site, as soon as it's connected (engine off) it's supposed to recognise the pc3 and what map's on it....I got nothing I then turned the bike on.....still nothing, I'm probably something...

As per the title. Ive got one to fit but seem to have more wires than connections! Can anyone give me a hint. :thumbup

Does anyone know what the correct width across the chain connecting link is on a DID 525 chain???? I don't want to pinch it too much and make the link stiff. I am using a chain riviting tool. I have been told the width across the link should be 17.4mm when press fitting, before riviting it...

Pulled my bike out of the garage today and it just collapsed at the rear!! :mad: Further inspection found it was the rear suspension connecting rod had split down the length. Anyone else had this? Lucky for me it wasn't mid corner!!!

Guys I have had the usual RSV electrical problems i.e. wont start first go, cutting out...blah blah. I replaced the starter solenoid with the 150 amp version and have replaced the battery. After I replaced the solenoid the bike was starting up better however on my commute the bike just...