adjusting

Just a strange question really, I've fitted a new Fuel F1 road exhaust to my 05 gen 1 tuono and wanted to turn the idle down slightly. I found a wheel/knob adjuster on the right hand side just below the tank. Am I totally wrong as it didn't seem to make much difference, so I tried to set it back...

Hi all, Wondered if anyone knew how the adjust the idle speed on 2004 rsv 1000 r as it's seems to drop very low after a minute or so of riding and occasionally cuts out

Hey folks I just checked the valve clearances on my recently purchaced track bike. A few of them are a bit tight and require adjusting. :angry Question is- is it easy enough to do with the engine in or is it an engine out job? It looks just about doable to me with the engine in, but has anyone...

Alright guys, Can anyone tell me how to take some rebound of the (yellow) Sachs shock on my '03 Tuono?? There is a knurled "nut" at the bottom of the shock but which way should i turn to take some off?? When bouncing the rear it is WAY to slow to come back up!!! Cheers.............:thumbup

Ello folks, Long time no see, not been here for a fair bit due to a shedload of work. Hardly had time to ride the thing. Anyway, I had a fresh set of steering head bearings fitted in April last year and recently they have started to feel a wee bit loose. Bit of a slight "knock/clunk" feeling...

I was reading earlier that the screws on the ECU are supposed to be at 12 o'clock stock. What is the best way to make adjustments to these? Do I need a special tool to make the adjustments and dyno it? Should they both cylinders adjustments stay the same or does one sometimes need more...

was up the cat n fiddle last week and there was a wet patch in the centre of the road half way up on the long staight(ish) part like there always is. i sat the bike up on the wet bit and clipped a cat's eye and kind of ripple in the road. bars shook pretty violently and **** me up a bit. think...

Please could anybody tell me how easy, or not, it is to adjust a chain length, im assuming you need a chain splitter, are there anyother tools required, or am I best just taking it to shop for saftey reasons etc. Thanks all.:dowhat