Joined Oct 2009
3K Posts | 1+
Where is everyone?
- Thread starter redratbike
- Start date
Joined Dec 2012
855 Posts | 0+
Near Portsmouth
Been mega busy with work mate and I've got an xr250 project im working on, anyone know much about them? Took the rsv round the IOW at the weekend which was fun!
Made a pumkin for halloween.. which I have since blown up lol
Getcha pumkins aaaaauuuuttt!
Made a pumkin for halloween.. which I have since blown up lol
Getcha pumkins aaaaauuuuttt!
Been busy chuffing about at work
Gearing up for the big strip and rebuild over the crimbo hols
Ohh , got me lc ready for an mot
Gearing up for the big strip and rebuild over the crimbo hols
Ohh , got me lc ready for an mot
Joined Oct 2009
3K Posts | 1+
Joined Oct 2009
3K Posts | 1+
Joined Oct 2009
3K Posts | 1+
Are you bored with the Mille then?...what style you doing the X-R?...flat tracker?
Joined Dec 2012
855 Posts | 0+
Near Portsmouth
Cheers mikee, I love it!
No not bored was in need of a project and been keen on getting a bike to use for green lane riding, never been off road on 2 wheels so should be a good crack.
I have picked up a 2nd hand gen2 engine with reported big end failure thats the next project
probably next winters though! Either gen2 heass on mine with 57's or the gen 2 engine in is the idea but may hold out for a couple of years and go big bore also Mille is ready for fine weather apart from the steering damper rattles about.
No not bored was in need of a project and been keen on getting a bike to use for green lane riding, never been off road on 2 wheels so should be a good crack.
I have picked up a 2nd hand gen2 engine with reported big end failure thats the next project
probably next winters though! Either gen2 heass on mine with 57's or the gen 2 engine in is the idea but may hold out for a couple of years and go big bore also Mille is ready for fine weather apart from the steering damper rattles about.If I remember rightly there is a sleeve that the bolt rotates in, these often corrode so badly that it can stop the bolt coming out, sometimes you can use a hydraulic press but more likely you might need to have it cut out.
