This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

What are these for???

I will borrow this thread a little bit :)

My question is not what are these, but what is this? :)
View attachment 5048
It a little hole on the back of the engine. I am wondering its purpose? Does anyone know?
Thanks.
 

Attachments

  • lukna.jpeg
    lukna.jpeg
    63.7 KB
Yeah I think that's gasket

Probably a little tab to hold it with when positioning it
 
U thanks for translation :) But I still do not understand the meaning of the hole, it seems that is all the way through inside the engine? Or does just look that way?
 
It's where two halfs meet and it's to stop fluid leaks, so it will go all the way through as such!

I'm guessing you don't have a hole in your engine!!!???

If you look at the drawing in this link it shows part 54 as the gasket and gives you an idea what thy do, I know it's a head gasket but you get the idea
 
The hole is not a hole, it's a lip between the crankcase halves to help lever them apart when splitting the engine.

HTH
 
Andywhedd said:
It's where two halfs meet and it's to stop fluid leaks, so it will go all the way through as such!

I'm guessing you don't have a hole in your engine!!!???

If you look at the drawing in this link it shows part 54 as the gasket and gives you an idea what thy do, I know it's a head gasket but you get the idea
Click to expand...

yes, my "hole" is sealed :) than it's ok, if it's only for separating the engine, I don't need to wory :)
 
Spider™ said:
I will borrow this thread a little bit :)

My question is not what are these, but what is this? :)
View attachment 5048
It a little hole on the back of the engine. I am wondering its purpose? Does anyone know?
Thanks.
Click to expand...

Which gasket is this? Has anyone replaced it? I have some small leaking from this point and winter is comming, so it is perfect time.
 
View attachment 5048
on this picture engine is very clean, mine has some burned oil in the middle (above marked hole). So crankcase gasket isn't sealing as it should.
I hope it can be done (I won't replace it on my own of course)
 
Valve cover gaskets are ok and may actually be dripping onto the crank case
.

but that isnt a clutch cover gasket thats the crankcase gasket for if you have had the whole side case off to get to the oil pump etc
 
×

Similar threads

D
RSV4 wheels to fit an ‘02 RSV Mille R
Replies
2
Views
362
D618ERT
D
J
Rs 457 Batterys drain
Replies
0
Views
90
joaofego
J
G
Fuel pump won’t prime in bike but will prime out of bike, need help bad
Replies
0
Views
198
Green
G
J
2022 Aprilia Tuono 660, no key bought at auction
Replies
0
Views
166
JerryW
J
gixxerniknik
Gen 1 rear brake solution.
Replies
0
Views
342
gixxerniknik
gixxerniknik

New Posts