This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Speed Sensor blowing fuse

Joined Apr 2009
20 Posts | 0+
Suffolk Coast
Hi guys,

I've had a good search around and I wondered if anyone could offer some insight.

Washed the bike at the weekend (hose but not jet wash) and went out for first ride of the season :thumbup

Which was great until bike cut out while overtaking on way home :banghead

Fuse D (15-amp) blown. When replaced it blows again as soon as the ignition is switched on.

Disconnected the speed sensor and rode home but service keeps flashing up.

Diag code reads (when SS is disconected):

P Code 0231
A Code 45
Fuel Pump

When SS is connected and fuse is blown diag reads same plus:

P Code 0616
A Code 50
Starter

I have checked the sensor at the hub for dirt

Running a continuity test across the sensor terminals I am getting continuity with all wires. I don't suppose this is normal but I wouldn't know.

Any tips or ideas... is it defo the speed sensor?

Does anyone know of a less expensive replacement or of anyone offering a good deal new or secondhand?

Can I run without the SS connected for a while (it's f'king sunny at last) or will that cause further issues?

Thanks for looking guys,

Dave
 
high pressure water and cracked sensor casing = blawn sensor. Had similar when I first got ma T, Blew the sensor right oot its mount when it shorted. As the fuse also covers the fuel pump circuit its an "all stop" so ended up trundlin tae a dead stop, totally flumox as tae whit had happened.

You sometimes get a bit o warning the speed sensors on the way oot prior as it will read random speeds like 380 mph an fluctuate up an doon.

Quite a common failure on the good auld Tuono actually.
 
×

New Posts