Sevice on LCD

longfingers said:

How can I get the service symbol of the display? My bike has been serviced only 500 miles ago, it only has 9000 on it. RSVR, 2000 model.:dunno

Click to expand...

Hi longfingers.

I had exactly the same problem and posted on here a few months ago about it as it was really annoying and I didn't want to have to go back to the dealer to sort it so I know how you feel. Anyway Spoonz came to my rescue and it's simple when you know how!

Basically all you need to do is hold the (+) and (-) buttons down simultaneously and then turn the ignition on. It may take up to 30 seconds to disappear so be patient and it may not work the first time so stick at it.

Let me know if it works. Good luck! :thumbup

PS. Mine's a 2008 model so I'm hoping the process is the same. If not my apologies. However I've no doubt that Spoonz or LEGS, among many others, will be able to help you very shortly.

LCD Dash Functions
Resetting the service light
Key on
Press Lap and R for 5 seconds
Switching KM/H to MPH
Key on
Press A about 5 seconds until blinking
Press B to change unit of measurement
Press A for 5 seconds to confirm choice
V max
Uses trip odometer #1 (the odometer displayed during instantaneous speed)
To reset trip odometer #1 press R for 2 seconds
To display V max and distance of trip odometer 1 press B for 2 seconds
To reset V max press R for 2 seconds
AVS (Average Speed)
Uses trip odometer #2
Hold down B for 2 seconds and then press again
AVS is displayed along with distance of trip odometer #2
To reset both AVS and trip odometer #2 press R for 2 seconds
Redline threshold (engine off only)
Press C, release, and press again
Release C when desired RPM is reached
Battery voltage
Press D once
Setting hour
Press D twice
Press LAP until desired hour is reached
Press D to confirm
Setting minutes
Press D three times
Press LAP until desired minutes is reached
Press D to confirm
Setting °C or °F
Press D a fourth time
Press LAP to alternate units
Chronometer (Lap Timer)
V max, AVS, and trip odometer #2 no longer function in this mode
Press LAP and within 0.7 seconds press D to enter chronometer mode
To start timing press LAP and release immediately
To store a lap time press LAP
To display lap times press B
To cycle through the stored laps, press LAP
To reset memory press A and LAP for 2 seconds
To leave chronometer function press LAP and D

hope this helps

Dave

probably a dumb question, but is there an alternative button to use than lap for getting rid of the service light and set the time etc?

Mine desn't work, or is it a relatively easy job taking the left handlebar controls apart to diagnose the problem?

Ignore last post... I've fixed the button now

Should make this a sticky Mods

nice bit of info dave cheers

Lap R button worked for me too, cheers.