About 10 days ago I did a very wet track day at Rocking on my Factory. All was well on the day and I took the bike home, gave it a wash, rode it into the garage and then took the fairing off to clean up inside.
With the panels off I spotted a tiny weep from the oil tank, so I removed that and got it fixed.
Today I put the oil tank back on, filled it with oil and fired it up. It ran for a few seconds as normal then dropped to 1 cyclinder, then stalled. I tried again and it fires on one cylinder only. Ive pull the rear plug lead off and given it a squirt of WD40, but that had no effect.
Before I start pulling it appart, is there any 'common' fault that could cause this?
Cheers
Steve
With the panels off I spotted a tiny weep from the oil tank, so I removed that and got it fixed.
Today I put the oil tank back on, filled it with oil and fired it up. It ran for a few seconds as normal then dropped to 1 cyclinder, then stalled. I tried again and it fires on one cylinder only. Ive pull the rear plug lead off and given it a squirt of WD40, but that had no effect.
Before I start pulling it appart, is there any 'common' fault that could cause this?
Cheers
Steve
