New key Gen 2

TomskiY · Apr 1, 2014

Hi everyone.
I'm certain someone will be able to give me some idea.
I need a new (spare) key for my '06 RSV1000R. How much would a new, genuine key cost from an official Aprilia dealer (I have the original key code). Also, I'd guess the new key would be supplied milled/cut and coded for the immobiliser.
Any help greatly appreciated.

ride4fun · Apr 3, 2014

Erm, call your nearest Aprilia dealer and ask them!

TomskiY · Apr 4, 2014

ride4fun said:
Erm, call your nearest Aprilia dealer and ask them!

Erm, did that but unfortunately they were almost as unhelpful as you!

ride4fun · Apr 4, 2014

Well, you won't be able to get one unless they're willing to give you some customer service. Whereabouts are you, in case I can be a bit more helpful?

Skullface · Apr 10, 2014

you can buy blanks from AF1, shipped over from USA, few local key cutters can cope, but it can be done, 3mm milling tip and a will to succeed. then any key place can clone your transponder iirc.

TomskiY · Apr 12, 2014

Skullface said:
you can buy blanks from AF1, shipped over from USA, few local key cutters can cope, but it can be done, 3mm milling tip and a will to succeed. then any key place can clone your transponder iirc.

Hi Skullface.
You can buy blank chipped keys from any Aprilia dealer or parts supplier, around £30-35.
I have also taken my original key to several key specialists and the general consensus is that they could cut/mill a blank key for me and possibly supply me with a cloned/programmed chip (that I would need to glue/tape/fit to the key) but are unable (or possibly unwilling) programme the key chip.
Thanks for your help anyway.

TomskiY · Apr 12, 2014

I know that genuiune blank, chipped Aprilia keys are readily available.
Maybe my original question(s) weren't clear enough.
My questions:
1. Is it possible to contact an official Aprilia dealer, give them the five digit code supplied with my original Zadi keys and be supplied with a new pre-cut/milled and (immobiliser) programmed key?
2. If "yes", how much (approximately) would a new key cost?

Spoonz · Apr 14, 2014

As long as you have 1 programmed key still u can use it to program a blank without special tools etc just a blue re code key which u can buy from a dealer (or use theirs). You only need the code pre programmed if you have no keys at all or a dealer with a red master key that will allow erasing of the immob ecu memory so a new key code can be programmed into it.

i am assuming you have 1 key still so all you need is a cut blank, blue key and the process to program the new one to match. it takes 10 mins so can't believe a dealer would charge much to use their key.

New key Gen 2

Help Support Aprilia Forum:

TomskiY

ride4fun

TomskiY

ride4fun

Skullface

TomskiY

TomskiY

Spoonz

Retired

Similar threads

New Posts