new falco motor in now getting codes 11 and 12

superyellow · Nov 6, 2009

11 camshaft position sensor
12 driving shaft position sensor
I have a male plug by the diognostics cable this white plug has two connectors and one of them have two cables with green + yellow and the other has solid green. where does this cable go and what is it? i assume this is why my bike is not starting... please helo

p.s. my fuel pump primes and gives EFI on drive mode and 11 and 12 on diagnostics mode. thank you in advance folks... :dunno

irate

cheesy1 · Nov 6, 2009

the camshaft position sensor is on the front cyclinder on the left hand side
its a white connector sort of rounded you'll spot it when ya see it

superyellow · Nov 7, 2009

okay so I was able to force start the bike with jumping the starter solenoid! When I let my hand go off the clutch the bike stalls I checked the Camshaft and the drive shaft positioning sensors I still get the codes 11 and 12 when I try to run the bike with the starter button only, and the bike doesn't start without jumping the starter solenoid.
I was thinking to test both of the sensors with an extension cord to my old motor. to see if it's the cable to the sensor or the sensor itself so i could get the bike move.
any suggestions?

cheesy1 · Nov 8, 2009

jumping the starter solinoid?

u mean ya bridging the connections?
then it will start?

superyellow · Nov 8, 2009

yes excuse my english. I used a jumper to short/bridge the starter solenoid. it starts only like that. and I think it "force" start the bike just like that because code 11 and 12 is "no start". The computer wouldn't let me start it. So what should I do

Search

Search

new falco motor in now getting codes 11 and 12

superyellow

cheesy1

superyellow

cheesy1

superyellow

Similar threads

New Posts