Mpl slave...dont seem to fit!!!help

wardy53 · Apr 28, 2009

Ive just tried to fit my mpl slave.but upon taking the standard one off,the mpl dont fit fully over the push rod.not allowing it to sit on the casing.around 50mm.im i doing something wrong.or maybe sent the wrong slave...thanks for info

BB1000 · Apr 28, 2009

piston in the MPL unit probably needs pushing in

viper · Apr 28, 2009

Make sure you have removed the "spacer" from the old cylinder, it is alloy like the old cylinder and looks like it is part of the unit, there are 2 distinct parts to the old cylinder and you'll need to use part of it.

I found exactly the same when I fitted mine, the "spacer" is about 50mm thick between the engine and the cylinder and will fit onto the mpl unit between it and the engine, just as the OEM one does......

Post if that helps.

wardy53 · Apr 28, 2009

that should do it then.thanks alot dude

B o B · Apr 29, 2009

When I received mine from MPL it too didn't seem to fit. I contacted them and they'd sent me one for a Ducati. :jack

wardy53 · Apr 29, 2009

thats it done & blead...i did not split the standad one to use as the spacer..took it for a short blast.not that much difference i dont think,but maybe on a longer run.

Search

Search

Mpl slave...dont seem to fit!!!help

wardy53

BB1000

viper

wardy53

B o B

wardy53

Similar threads

New Posts