Installing New Ignition
- Thread starter babutler
- Start date
-
- Tags
- ignition installing
think it was mentioned over on RSVR.NET ...cut a slot in it with a hacksaw and then use a screw driver...you need to strip the front fairing off...sounds fiddly as i have to do the same thing to recover a snapped key out of the barrel
ive had to do this a few times its a little tricky but as mark says there is a few methods that can be succesful doin this!!
another trick is using a small hammerand a centre punch and tap the domed head round until it comes loose enough to wind out by hand!
or you can cut a slot into it with a hacksaw....im not 100 % sure but im sure sme of them had the bolts recessed which does make life a little trickier!!
not impossible though dude!! good luck!!
Griff
another trick is using a small hammerand a centre punch and tap the domed head round until it comes loose enough to wind out by hand!
or you can cut a slot into it with a hacksaw....im not 100 % sure but im sure sme of them had the bolts recessed which does make life a little trickier!!
not impossible though dude!! good luck!!
Griff
Joined Jul 2008
207 Posts | 0+
I've got the whole thing stripped down. I'm almost finished the rebuild but I can't find the key. I got two new keys, ignition, rear lock and gas cap from Timebikemachines on ebay. All I need now is a new tip over sensor and the banjo bolts for the fuel line I just ordered.
