Installation of PC autotune

Foggy2703 · Aug 1, 2014

Im guessing this has been asked before many times but how do I install the O2 sensor
And I just replace the original and leave it connected to the pc v optimiser?
Do I HAVE TO drill another hiker and weld bung in place?
Could I use the "spare" plugged bung coming off one side of the head( by the main rear suspension spring)?
Any advice or tops gladly taken on board!

Cheers

Zuki · Aug 1, 2014

I would say just put the sensor in where the standard one goes, as the standard one will be redundant now if you have the optimiser plugged in.
but in all honesty unless you got the autotune really cheap < Â£100 i would say the money would have been better spent on a proper dyno tune.
all the auto tune does is make sure the air fuel ratio is constant. which is great for emmisions but not so good for power, sometimes it's needed to be slightly rich/lean dependant on the revs and throttle position.

Foggy2703 · Aug 1, 2014

Cheers for tha quick response!
Yes I was given the autotune so yes it was cheap- lol
I just was unsure as I read somewhere if I take out the stock sensor it give an error code wasn't sure if this would I turn effect the bikes running

Zuki · Aug 1, 2014

FREE !!! that's a result

the stock sensor isn't connected any more if you have the 02 eliminator installed trace the wires back from it.

Search

Search

Installation of PC autotune

Foggy2703

Zuki

Foggy2703

Zuki

Similar threads

New Posts