Help. Quickshifter for pc iii usb, don't work right

queensmile · Mar 18, 2012

Hi,

I have one if this in my bike, it's the pull sensor for reverse gearshift.

I've configured ir as standart, starts working over 4000rpm with a 'cut' of 65 msec. But in most of the cases when I am in acceleration appears a micro cut (the same as if I was gearing up). It's a **** :bangwall: :bangwall: :bangwall: :bangwall: and I don't know how to solve it.

Does anybody have a similar quickshifter with the same problem? How did you solved it? Some suggestions?

Thanks

bryanthegoat · Mar 20, 2012

Did you buy second hand m8?? if so did you get the instructions and setup cd,i take it its connected to the pc3 and you have enabled it with the correct cd?? if these are all yes then you might have to adjust the length of the shift rod by adjusting the nuts a bit mines took an age to get to work when i had it my daytona now has a cordona one which i fitted in 30mins a hell of allot better than the dynojet one

andirsv1 · Mar 21, 2012

Buddy, had a very similar thing and this fixed my problem....

Make absolutely sure the cable from the sensor is not running near ANY other electrical wires or cables, even the battery!!! I run mine on the underside of the rear subframe, away from ALL other electrical wires and it was spot on instantly!

Search

Search

Help. Quickshifter for pc iii usb, don't work right

queensmile

bryanthegoat

andirsv1

Similar threads

New Posts