Help needed with imboliser problem

jnewton177 · Mar 28, 2012

HI people im new to all this forum stuff and need some help
i have a 2007 mille R and i have what i think is a problem, the immobilizer light flashed when the bike is off, i can put the key in start it and ride it fine but the light keeps flashing, ive looked all over for some help but cant seem to find any, so any advice would be awsome
thanks
josh

Spoonz · Mar 28, 2012

The immobiliser ecu's on these are not that good. They suffer water ingress and especially broken/duff solder joints internally. Your has the classic symptoms of joint issues and the next step is usually bike runs with key out or won't run at all.

You either need to split open the immobiliser ecu and re solder and seal or have it replaced. If you replace it you will have to have it programmed to your keys also.

Don't ignore it as it will get worse.

jnewton177 · Mar 28, 2012

Would you happen to know where the imboliser Is located ?
Many thanks
Josh

Spoonz · Mar 28, 2012

jnewton177 said:
Would you happen to know where the imboliser Is located ?
Many thanks
Josh

Yes :devious

Take left side panel off. Look on the black inner fairing panel at about rad height. You will see a black box about 3 x 2 inches with ZADI written on it.

That's your problem. Before you pull it apart, check and clean the connectors in it's loom as they can be prone to corroding

jnewton177 · Mar 29, 2012

Is there anyway to by pass the immobiliser if need be ?

Spoonz · Mar 29, 2012

Yes but i'm not gonna post it on a public forum or bye bye lots of Rsv's

Pm me if it comes to that.

Help needed with imboliser problem

Help Support Aprilia Forum:

jnewton177

Spoonz

Retired

jnewton177

Spoonz

Retired

jnewton177

Spoonz

Retired

Similar threads

New Posts