What year is ur rsv?
I done the wifes 08 tuono last night and im sure its was the same as my 08 rsv
All the wiring needs ran to under the back seat except the orange wire which needs to go to an earth somewhere,
You will need at least 8m wire , solder iron,heat shrink or good tape and cable ties
Connections for a later tuono and probably the later rsv also
Black is groung/negative goes to battery or dark blue to tail light
red is ingnition live and you connect that to the yellow that goes to the tail light
yellow is the tachopulse and that goes to connector a pin 33 grey/red
green is the speedo pulse and goes to connector b pin 6 grey/white
brown is the neutral lightand goes to connector b pin 40 heavy black
and orange is the learner wire
Once connected switch the ignition on and hold the orange wire to earth till the reading shows flashing p
disconnect the orange wire and touch it on and off till you see 6 showing on the digi, it will go 1 2 3 4 5 6 as you touch it
Then start the bike in neutral then drop into first and rev the bike over 2000 revs till the 1 flashes faster then goes to a bar
change gear to neutral and pause then move to second and rev to over 200 till again the 2 flashes fast and changes to a bar
Do this for all gears
Voila
P.s. if your bike is an old slow one then disregard the above lol
