"for race use only"

Olllie · Jun 20, 2009

Any one got any good tips of getting this off of my titanium cans?

cheers Ollie

Dolenc · Jun 20, 2009

Have a "NOT" engraved at the beginning

Olllie · Jun 20, 2009

:thumbup

A303 · Jun 20, 2009

Dolenc said:
Have a "NOT" engraved at the beginning

:lol:lol:lol

Sprocker · Jun 20, 2009

Use a Dremel to grind & polish it out :thumbup

spoonz · Jun 20, 2009

Leave it on there.

A proper race can without any kind of baffle ain't fooling any traffic cop worth the name and removing it will get you fined with "peverting " " " etc as well as having a noisy can.

if you have removable baffles maybe, if not leave it alone imo.
Were i to do it i would remove the strap and turn it around so the writing is on the inside.
Half a dozen blind rivets and bobs ya uncle

Sprocker · Jun 20, 2009

No baffle in mine spoonz and never had any bother from mr plod :devious If i did i'd just say the can was on the bike when i bought it and act dumb :dunno not that that'd be too hard to do :biggrin

Eeza · Jun 21, 2009

spoonz said:
Leave it on there.

A proper race can without any kind of baffle ain't fooling any traffic cop worth the name and removing it will get you fined with "peverting " " " etc as well as having a noisy can.

if you have removable baffles maybe, if not leave it alone imo.
Were i to do it i would remove the strap and turn it around so the writing is on the inside.
Half a dozen blind rivets and bobs ya uncle

:thumbup Do this its easy, I have just re-packed the Can on my Ninja :bounce

HondaCBRrr06 · Jun 21, 2009

U could buy a BS plate with the Kite mark and code on over the internet and rivet it over the "NOT for Road use"
:thumbup

Les Tap · Jun 21, 2009

Or weld a heal heat shield over where is sez it like ive done,providing its an Aprilia race pipe where its etched on the link pipe under your foot,simples

Olllie · Jun 21, 2009

Les Tap said:
Or weld a heal heat shield over where is sez it like ive done,providing its an Aprilia race pipe where its etched on the link pipe under your foot,simples

correct! i shall do this tomorrow or may even extend the previous one...

cheers "les tap"

camngetit · Jun 21, 2009

did mine at work titanium aprilia can used a da /sander to flat out the writing the polished it up no writing on it at all looks like new just getting the nice golden colour on it

Les Tap · Jun 21, 2009

We recently did a job in work that required me to buy some 2 mm thick stainless perforated sheet,2mm holes at 6 mm centres,got one of the sheeties to buff a 200mm by 65mm piece up for me on friday and I rolled it to a 80mm circumference,it looks pretty good,going to tig weld a couple of 6 mm s/s nuts to the link pipe tomoz then buy some M6 dome head cap screws to mount it on with,if I can work out how to post pics I'll put some on of the finished article,doing some other "mods" to the end can to :megaphone

"for race use only"

Help Support Aprilia Forum:

Olllie

Dolenc

Guest

Olllie

A303

Guest

Sprocker

spoonz

Guest

Sprocker

Eeza

HondaCBRrr06

Guest

Les Tap

Olllie

camngetit

Guest

Les Tap

Similar threads

New Posts